Model #61200 HONEYWELL Air Cleaner

  • Air Cleaner
    3 Results
Find part by diagram >

Question and Answers

Q:

How old is my Kenmore Laundry Center

A:

An expert shall have an answer to your question shortly. Usually an expert will respond to a question within 24 to 48 hours. Have a wonderful day.

Read More
Alina F. -
May 26, 2011
A:

The serial number indicates the date of manufacture. I provided a chart in the image below that shows how to decipher that date code. The third digit is the year of production. The 4th and 5th digits show the numerical week during that year that the laundry center was manufactured.

This should help you determine the age. If you need more help, let us know.

Read More
Lyle W -
Sears Technician
May 27, 2011
A:

Lyle, My Serial # is W32217047, there is no "B" after the "W". I take this Laundry Center to have been made in 2003 in the 22 week? Is my assumption correct?

Read More
Bruce Marshall -
June 03, 2011
A:

Possibly. I can normally use the model number to verify that date but your model number appears to be slightly off. I recommend that you recheck that number. It may have a digit such as 3 between the second 9 and the 7 (417.99370820). For that model number, it would have been produced in the 22nd week of 1993. The year digit does not indicate the decade that it was manufactured. Reply with a revised model number if you need more help.

Read More
Lyle W -
Sears Technician
June 04, 2011
A:

Lyle, I rechecked the Model & Serial Numbers on Sears Sticker off the top panel and the just inside the dryer door. They are the same as I stated. Does this mean that the year made is 1993?? I think it is newer than that!! Bruce

Read More
Bruce Marshall -
June 04, 2011
A:

I don't have information on the exact model 417.9970820. There are many different models that begin with 417.99 . . . I did not find any models that begin with 417.997 . . . Without a model number that I can access information for, I can't tell whether that laundry center was manufactured in 1993 or 2003. If you have an owner's manual for that laundry center, you can check the copyright date of that document to help you narrow down the decade.

Read More
Lyle W -
Sears Technician
June 04, 2011
A:

Lyle, the Sears sticker on the top panel with the model # & serial #, the date printed on the sticker lists 5/93. I would assume that this was made in 93? The model # & serial numbers are what I found on both the Sears sticker on the top panel & inside the dryer door.

Read More
Bruce Marshall -
June 04, 2011
A:

Lyle, I have found the model # off the website: 41799170820 Kenmore Laundry center. I was looking for exploded views of the different parts. So the model number is a good one I would assume.

Read More
Bruce Marshall -
June 04, 2011
A:

That model number 417.99170820 is good. It looks like you left that digit "1" between the 9 and 7 out in your original details. Since you saw the date of 5/93 on the sticker, the date of manufacture should be 1993.

Read More
Lyle W -
Sears Technician
June 06, 2011
A:

Lyle, thanks for you help!! This Kenmore Laundry Center is a pain in the butt. We have spent $512.00 into a machine that is 18 years old and the dryer will not work. We have put a new pump in the washer. The washer works fine. Put a new heating element in the dryer tested the fuse/limiter and found to be OK, put it all back together and the dryer will not start. Any suggestions!!! Bruce

Read More
Bruce Marshall -
June 06, 2011
A:

If the dryer was running before you took it apart, make sure that you plugged the door switch wire harness connection back in. Check the house electrical breakers or fuses for the 240 volt outlet that you are using for that laundry center. The dryer motor on that type of laundry center normally runs off of the L2 leg of 240 volt power. If you have a volt/ohm meter and you are confident that you can safely check the dryer outlet voltage, you can use the diagram in the image below to verify that you have the correct voltage at that dryer outlet. Don't conduct this test unless you are completely confident in your technical ability to safely measure that outlet voltage. If that outlet voltage is okay, then you could have a problem with the dryer door switch since you indicated that you already checked that thermal limiter. A wiring problem or a timer failure could also cause this problem. I hope that this information helps. If you need more assistance, reply with additional details. NOTE: Be sure that you UNPLUG the laundry center before accessing internal components.

Read More
Lyle W -
Sears Technician
June 06, 2011
A:

Lyle, Thanks for all your help!! I tested & replaced the thermal limiter, found wires that were burned, fixed those there must be a short some where. When I put it all back together and started it, it must have blown the theromo fuse/limiter again. We have decided not to put anymore money into this machine, we have put $612.00+ into this machine.

Read More
Bruce Marshall -
June 08, 2011
See more answers