Model #600 GENERAL Kitchen Equipment

  • Replacement Parts
    3 Results
Find part by diagram >

Question and Answers

Q:

My vissani beverage cooler quit cooling MCBC58DST Vissani 5.8 liter beverage cooler

A:

Thank you for choosing SearsPartsDirect.com. I will be more than happy to assist you. I can understand any frustration you may have experienced with regards to your unit. Let’s see what we can do for you.

Looking into the information on this Vissani beverage cooler I'm showing the main issue could be the compressor. When these stop working (Not Cooling, I would normally point to the protector, or starter. These are on the side of the compressor and are what allow it to run properly. If you take them off you can shake them if they rattle they might need to be replaced. The part number for this is 312200500113.

Hope this information has helped you. If you are not comfortable doing this repair you can click here to schedule a technician or call toll free 1-800-469-4663. Again, thank you for choosing SearsPartsDirect.com.

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
JeffwallaceIII -
Sears Technician
July 03, 2015
A:

I just had this happen with my Vassani beverage cooler. It was indeed the starter device. It's located on the left side of the compressor and pulls off easily. Here's what you do: To get to the compressor, remove the back panel. You then have to remove a cover that is over the starting device (on the left side of the compressor). The cover is held on by a thin metal tension spring. Pull this off and you'll see the starting device with a lead wire attached to it, on the side of the compressor. Pull off the lead wire and you should be able to wiggle the device free. If it rattles, it's broken. I'm not a repair guy but there's a ceramic disk inside the device that's about the size of a quarter that looks like it serves as some sort of conduit limiter between two sets of prongs/contacts. I'm probably all wet but anyway mine was broken and fell out in a bunch of little pieces. Ordered a replacement part from Home Depot for $28.00 plus $6.00 shipping. Put the new one on and it works like a charm....nice and cold.

Read More
Corey -
January 31, 2016
See more answers
Q:

maytag dryer medx600xw0

A:

Thank you for choosing Sears Parts Direct. I will be more than happy to help with your dryer. Upon researching model medx600xw0;  I have posted an image of instructions for how to disassemble the unit.

I trust this information will help you, we appreciate your business thank for choosing Sears.

 

Read More
CarlosZ -
Sears Technician
March 12, 2015
A:

My maytag dryer medx600xw0 is making a loud and squeaking and screeching sound after it's on for several minutes. Also, how do you disassemble the unit?

Read More
Glenn Landhan -
January 27, 2016
See more answers
Q:

Radial Arm Saw Recall ? 113199250 Craftsman Craftsman 10-inch radial saw

A:

Thank you for being Sears' valued member; and thank you for contacting SearsPartsDirect.com with your questions about the recall on your Craftsman 10-inch Radial Saw model 113199250. I am so sorry your saw was affected by the recall. For assistance with your options under a recall, please contact our Recall Customer Care department at 1-800-659-7026. To ensure you are given all of your options, I will defer to our Customer Care advisors' expertise. If I can be of further assistance, please let me know.  Thanks you for choosing Sears, we appreciate your business. 

Read More
Rachel Morgan -
Sears Technician
September 29, 2014
A:

Hello, I also have this radial saw model, can I also contact recall customer care department at 1-800-659-7026? Is isn't to late to get help with this issue is it?

Read More
Gilbert -
May 26, 2015
A:

I just found out this saw was recalled, and was mad as hell since I had also never seen the recall on the Sears site, only through word of mouth some 20+ years on. I lost the end of my index finger due to this very problem, and since I registered my product (a long, long time agao at purchase, I have never been notifieed of a recall and only found this thanks to someone pointing i out in a forum. The fact is, the $100 check is a rebate check and a joke if you suffered an injury like I did. I just sent off my 3rd email about this, as my saw is in near mint condition and has been well cared for. I only found the recall last week by pure accident, even though I registered my product like I do with all my tools. The kick in the teeth is that to even find workable parts, the price tag runs well over $600 as far as I can tell, and if the parts are not available, a new saw like this is between $1000-$1500. Instead of a check for a measly $100, how about covering the cost of a new finger tip Sears? Do they even understand the pain, loss and work issues a guy goes through after something like this? And at the time, they basically skirted the issue and made me feel like I had been the one at fault. Not cool.

Read More
David -
December 20, 2015
A:

Craftsman 10"radial saw MN 113.197751 I just found out this saw was recalled, and was mad as hell since I had also never seen the recall on the Sears site, only through word of mouth some 20+ years on. I lost the end of my index finger due to this very problem, and since I registered my product (a long, long time agao at purchase, I have never been notifieed of a recall and only found this thanks to someone pointing i out in a forum. The fact is, the $100 check is a rebate check and a joke if you suffered an injury like I did. I just sent off my 3rd email about this, as my saw is in near mint condition and has been well cared for. I only found the recall last week by pure accident, even though I registered my product like I do with all my tools. The kick in the teeth is that to even find workable parts, the price tag runs well over $600 as far as I can tell, and if the parts are not available, a new saw like this is between $1000-$1500. Instead of a check for a measly $100, how about covering the cost of a new finger-tip Sears?

Read More
David -
December 20, 2015
See more answers