Model #59671109101 KENMORE Bottom-Mount Refrigerator

  • Door Handles/accessories
    3 Results
  • Controls/light Covers
    3 Results
  • Evaporator/freezer Control
    3 Results
  • Shelving Assembly
    3 Results
  • Cabinet Back/water Valve
    3 Results
  • Mahcine Compartment
    3 Results
  • Insulation And Roller Assembly
    3 Results
  • Light Switches/drain Funnel
    3 Results
  • Door Assembly
    3 Results
  • Icemaker Assembly
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Where is the water fill on kenmore so that I can adjust?? 59671109101 Kenmore Refrigerator

A:

Thank you for choosing Sears Parts Direct. I do apologize I was unable to search your question. If you do not mind would you please explain what you are needing with your Refrigerator? What is going on? Noises? Etc.

 
You can also visit searpartsdirect.com for parts, diagrams, and repair information.
 
 
If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services.

Thank you for your question. Have a great day. 

Read More
Natasha12 -
Sears Technician
April 15, 2014
Q:

Kenmore bottom freezer refrigerator ice maker leaking and freeaing

A:

It can be very frustrating when your fridge begins to malfunction and not work properly. I did some research on the problem and provided a link to a similar question and answer on our site. I hope this will shed a little more light on the issue until the Expert responds to your question in more detail within 24 to 48 hours.

Read More
Julio -
September 18, 2012
A:

Thank you for your question. I understand your concern about the water leaking. It seems the icemaker may be overfilling and creating this problem. This could be a problem with the water valve or the icemaker itself. First, try adjusting (reducing) the water fill on the icemaker. I'm attaching a picture with instructions to make this adjustment. If it still overfills, the water valve # 12490801 will need to be replaced. I hope this will help you. If you would like more assistance, reply to this thread and I will be glad to assist you further.

Read More
Scott D -
Sears Technician
September 20, 2012
See more answers
Q:

How do I install a new gasket (part #12550101Q) on our pull-out freezer door (Kenmore 596.71109101)?

A:

First disconnect power to the refrigerator. Next remove the 4 screws holding the freezer door bracket (see picture) and remove the door. With the door loose, you can lay it down flat, with the inner door facing upward. Now lift the gasket lip so you can remove all of the screws (# 19) all the way around the door. With all the screws out, you can now slide the gasket off of the inner liner (# 17). Pay attention how the gasket lip fits on the liner. With the new gasket in place, now line the holes back up and reconnect the inner panel to the outer panel. Reconnect the door back on the bracket and if there are any gaps in the gasket, use a hair dryer to straighten them out. Be careful not to get the gasket too hot. If you need more assistance, you can resubmit your question with more details.

Read More
Scott D -
Sears Technician
October 26, 2009
A:

I am about to order this part from Sears. I am thinking I will TRY to replace this myself (due to the $75.00 cost to have someone come out here and do it for me). I am concerned though that the gasket is a bit much...they are asking $55.00 to have the gasket order and shipped to my house in about a week. Is that correct or could I buy this item somewhere cheaper??

Read More
Joseph -
September 21, 2011
See more answers