Model #59671102101 KENMORE Bottom-Mount Refrigerator

  • Door Handles/accessories
    3 Results
  • Controls/light Covers
    3 Results
  • Evaporator/freezer Control
    3 Results
  • Shelving Assembly
    3 Results
  • Cabinet Back/water Valve
    3 Results
  • Mahcine Compartment
    3 Results
  • Insulation And Roller Assembly
    3 Results
  • Light Switches/drain Funnel
    3 Results
  • Door Assembly
    3 Results
  • Icemaker Assembly
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

dimensions 59671102101 Kenmore Refrigerator

A:

Thank you for choosing Sears Parts Direct. I will be more than happy to help with your refrigerator. Upon researching model 59671102101;based on the model number provided, this model is 20.5 cu.Ft, Length:3F0.3, With:3F0.7,, Height:5F11.2.

I trust this information will help you, we appreciate your business thank for choosing Sears.

Read More
CarlosZ -
Sears Technician
July 30, 2015
Q:

freezer/fridge problem: too cold, frozen food in fridge, runs constantly

A:

Thanks for the information about your refrigerator model 596.71102101; sorry you are having a problem, I will be glad to assist you. Based on you description of the freezer food, walls, liner and other areas of freezer frosting over the only conclusion is warm air intrusion into the freezer.  This will cause the excessive run time which will cause the freezing in the fresh food section as well. I suggest that you inspect all the doors for proper sealing all around as that will be the most likely cause of this air getting into the unit. You will need to adjust or repair accordingly. Should you need parts here is a link to Sears Parts Direct. If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link: Sears Home Services.Ron H.

Read More
Ron H -
Sears Technician
October 12, 2013
A:

Thanks, Ron H. As a last-ditch effort to avoid a service call and repair costs, I unplugged the appliance for about 16 hours--I removed everything and let it air dry/warm (and gave it a good cleaning while I was at it). I plugged it back in about 24 hours ago, and all seems to be back to normal. I suspect there'd been ice built up somewhere--maybe interfering with the thermostat, or maybe preventing the seal from fully sealing. At any case, things seem ok for now, thank goodness!

Read More
jill -
October 13, 2013
A:

Hi Jill, I hope it continues to operate well, if you need more help feel free to contact us again. Ron H.

Read More
Ron H -
Sears Technician
October 14, 2013
See more answers
Q:

Refrigerator gasket/seal for refrig. door -how to install? 596.71102101

A:

 

Thank you for choosing ManageMyLife.com and allowing us to help you. It is always a little frustrating when a key appliance becomes compromised. You did not go into detail about what you are dealing with. If the bottom door is the issue. The image below may be helpful to you.

Replacing door gaskets can be tricky and sometimes difficult even for technicians. To replace the gasket, first, either turn the unit off or disconnect the power to it. Next, remove all items in the doors and now remove the top refrigerator door hinge. With the hinge off, you can lift the door and remove it from the unit. Now remove the center door hinge and you will be able to lift and remove the freezer door. Now lay the door down and lift the lip of the gasket, to expose all of the screws under it. These screws hold the inner panel and gasket in place. Remove all of the screws and slide the gasket off. Pay attention to how the gasket fits in place. Now slide the new gasket back on the panel, aligning the holes in the gasket with the holes in the panel. Reinstall all of the screws but don't tighten them yet. Now place the door back on the cabinet and close it. The door will be bowed and you will have to bow it back in place. When this is done, tighten all the screws to hold the door in place. If there are any gaps in the gasket, you can use a hair dryer to straighten them out but be careful not to get the gasket too hot. Now you can reinstall the refrigerator door and top hinge. As stated earlier, this can be difficult sometimes.

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact your local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others. Wear appropriate hand protection when working around sharp metal parts.

If you do not feel comfortable repairing this problem yourself, you can have it repaired at your home by a Sears technician. Click here to schedule service at the Sears Home Services website. A 10% discount coupon is available when service is set online.

If you have any follow-up questions, please continue our conversation on this existing thread.

Thanks again for choosing ManageMyLife.com.

 

 

 

Read More
James -
Sears Technician
October 10, 2013