Model #58716189401 KENMORE Dishwasher

  • Control Panel
    3 Results
  • Door
    3 Results
  • Tub
    3 Results
  • Motor & Pump
    3 Results
  • Frame
    3 Results
  • Racks
    3 Results
Find part by diagram >

Troubleshooting

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Leaking Kenmore Dishwasher (heater nut failed)

A:

 Managemylife.com is always a great resource to find the answers to just about anything. Your expert will research your question and respond within two business days but usually sooner.

Read More
Yadira B -
June 02, 2013
A:

I know that it can be very difficult to have issues with your dishwasher. On your model the dishwasher nuts are under the unit. You will need to pull the dishwasher out of the space and flip it on it's back. From there use a crescent wrench to loosen the nuts, then finish removing them by hand. I hope this helps. If you need further assistance, please reply to this thread. Thank you for using Manage My Life.

Read More
AnneJ -
Sears Technician
June 03, 2013
See more answers
Q:

Kenmore Dishwasher model 587 - Flashing 'Wash' Light issue 58716189401

A:

Searspartsdirect.com is always a great resource to find the answers to your parts questions. Your Sears partsdirect expert will research your question and respond within two business days but usually sooner. Thank you for using Searspartsdirect.com!

Read More
Joseph P. -
April 23, 2013
A:

I know that it can be very difficult to have issues with your dishwasher. The washing light is blinking and not starting because it does not detect the door being closed. Based on your symptom, one of the two door switches is not closing when the door is closed. NOTE: Disconnect the dishwasher from the power supply before access and checking the door latch and door switch operations. I'd suggest a technician check and repair this problem. then you can have it repaired at your home by a Sears technician. Just click on this link to schedule service: Sears Home Services . I hope this helps. If you need further assistance, please reply to this thread. Thank you for using Manage My Life.

Read More
AnneJ -
Sears Technician
April 24, 2013
See more answers
Q:

kenmore dishwasher model 58716189401 won't start

A:

Hello, I understand the dishwasher just stopped working. One of the places I check for causes is the troubleshooting guide in my owner's manual. I found and attached the link to your manual. See page 17. I also found and added a link to an appliance repair web site that offers some possible solutions. You can view if you like while waiting for the expert answer. Hope this helps!

Read More
Barbara H. -
July 18, 2010
A:

If the lights are all on but the dishwasher will not fill, wash or drain then the most likely cause of this problem is a bad door switch.

With a bad door switch the control will still have lights and display but it will not have any voltage to run the motor or water valve.

I'd start by checking the door switches. The two switches should have continuity through them when the switch is activated.

The 154556703 latch assembly is available from the following link: Sears PartsDirect .

I hope this information is helpful to you.

Read More
Fred M -
Sears Technician
July 20, 2010
See more answers

Top Parts