Model #5871574590 KENMORE Dishwasher

  • Console Panel
    3 Results
  • Detergent Cup
    3 Results
  • Door
    3 Results
  • Tub
    3 Results
  • Motor, Heater & Spray Arm
    3 Results
  • Frame
    3 Results
  • Rack
    3 Results
Find part by diagram >

Troubleshooting

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Cleaning of dishwasher filter

A:

Thank you for submitting your question, I can understand your concern. I will be glad assist you today. It is only recommended that you clean the surface of the filter. In order to remove the filter you will have to remove the spray arm first. I provided you a image below to help you. The filter is snapped in place, so just pull up to remove. If you need additional assistance, please reply to the thread below. Thank you for choosing Manage My Life.com.

Read More
Maira -
Sears Technician
August 19, 2013
A:

The image you have provided DOES not match my dishwasher. I can only do what picture #1 shows. Step #2: My dishwasher does not have 8 Torx screws. I've tried to load pictures but it did not work. (?) They have been added to my FB and this is the link. I hope you will be able to see it. https://www.facebook.com/kathyta.miyuki/media_set?set=a.611789072198842.1073741858.100001032639384&type=3 Thank you!

Read More
Katia -
August 19, 2013
See more answers
Q:

My Soap dispenser of the kenmore washer does not work. removed the front cover found a green wire disconnected. I do not have a wire diagram..

A:

While your waiting on an expert response, you could visit the Sears Home Services website to schedule service. I have provided the link below. I hope your dishwasher will soon work properly! http://www.searshomeservices.com/

Read More
Jacqueline S -
October 29, 2010
A:

The two red wires to the dispenser are the key. The green ground wire will not be a factor in the dispenser not working.

I thing to check first is the heating element.

Turn the timer to a dry cycle and see if the element gets hot.

One of the red wires from the dispenser runs to the heater. If the heating element is open then the heater won't work and the dispenser won't work.

A clamp on amp meter to check amp draw is the best way to check this problem. The voltage runs through the dispenser bimetal and not to it. You should see approximately 5 amps for the dispenser door to open. Use caution if you check this.

The problem will be on with the timer, dispenser or heater.

Check the heater first and replay with any additional details for further assistance.

Read More
Fred M -
Sears Technician
October 30, 2010
A:

Thank You for the expert suggestion. Checked the dry cycle as suggested nothing happened. Closer inspection of the bi metal element revealed it was broken on the rear portion of the element. Will purchase a new one today. Dave

Read More
Dave C -
November 02, 2010
A:

Glad to help and let us know if there s anything else we can do to help.

Read More
Fred M -
Sears Technician
November 02, 2010
See more answers

Top Parts