Model #58715104800 KENMORE Dishwasher

  • Control Panel
    3 Results
  • Door
    3 Results
  • Tub
    3 Results
  • Motor & Pump
    3 Results
  • Frame
    3 Results
  • Racks
    3 Results
Find part by diagram >

Troubleshooting

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Flashing Dishwasher Lights

A:

Flashing dishwasher lights are often a code to advise of a specific problem. A suggestion I have to help the expert provide the best possible answer is to add the make and model number of your dishwasher to this thread. Just click on reply box and add additional information. If you decide to schedule a qualified technician to help with diagnosis and repair, an option is the Sears Home Services link below.

Read More
Barbara H. -
January 20, 2012
A:

The Model number for the Kenmoer Dishwash is 587.15104800. Also I went to the circuit breakers and reset the circuit just to make sure that was not a problem and it did not help anything. Still the blinking lights. Also the model has no actual buttons just a smooth panel that can be washed.

Read More
Michael -
January 20, 2012
A:

Thank you for replying with your model number. The likely reason why your dishwasher is not starting and flashing the led lights is because the line one (L1) door switch is not closing when the door is shut. The L1 door switch has two (2) black wires attached to it and when the door is shut the door switch must close and send voltage to P2-3 terminal on the control board or it will not start.

The door latch assembly comes with two door switches installed in the latch assembly.

I recommend calling a service technician to diagnose and repair your dishwasher

Read More
AnneJ -
Sears Technician
April 13, 2012
A:

Thank you for replying with your model number. The likely reason why your dishwasher is not starting and flashing the led lights is because the line one (L1) door switch is not closing when the door is shut. The L1 door switch has two (2) black wires attached to it and when the door is shut the door switch must close and send voltage to P2-3 terminal on the control board or it will not start.

The door latch assembly comes with two door switches installed in the latch assembly.

I recommend calling a service technician to diagnose and repair your dishwasher

Read More
AnneJ -
Sears Technician
January 22, 2012
A:

Image

Read More
AnneJ -
Sears Technician
January 22, 2012
See more answers

Top Parts