Model #58715074201 KENMORE Dishwasher

  • Control Panel
    3 Results
  • Door
    3 Results
  • Tub
    3 Results
  • Motor & Pump
    3 Results
  • Frame
    3 Results
  • Racks
    3 Results
Find part by diagram >

Troubleshooting

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

I have a Kenmore dishwasher that I am moving from one property to another. In the move the a wire was disconected and I need the wiring schematic. 587.15074201

A:

Managemylife.com is a great place to find the answers to just about anything, especially on appliances. I'm sorry about the difficulties your having with your Kenmore Dishwashers Wiring. I did some research for you at Managemylife.com and found an expert answer to a similar question that I hope will help until your expert can answer your specific question. I attached the link below. This is not your Kenmore model # but may help until your expert can respond to your specific inquiry.

Read More
James -
July 12, 2011
A:

Thank you for your question and I understand your concern.

I added the wiring diagram in the image below.

Read More
Joey S -
Sears Technician
July 13, 2011
See more answers
Q:

I have a kenmore dishwasher model 587.15074201. it is leaking water and i believe the "gasket, door, bottom" needs to be replaced. How do I replace it?

A:

If you need to replace the gasket to your Kenmore Dishwasher you can purchase the gasket at the Sears Parts Direct.com. I found a question in Manage My Life that is similar to the one you asked. This question should give you some instructions on how to replace your gasket to your Kenmore Dishwasher. I attached the link below, I hope this helps!!!!!

Read More
Raquel F -
October 16, 2010
A:

I understand your concern. In order to access and replace the lower door seal will require removing the outer door panel.

Disconnect the power supply from the dishwasher first by flipping the circuit breaker off dedicated for the dishwasher circuit. The outer door panel is held to the inner door panel by two screws and four locking tabs, two on each side of the door.

Remove the lower two screws, one on each side that secures the outer door to the inner panel. Close the door and slide the door panel down and outward to remove.

Once you have the outer door panel removed you will see screws securing the lower door seal.

Read More
Joey S -
Sears Technician
October 18, 2010
See more answers

Top Parts