Model #58714012406A KENMORE Dishwasher

  • Control Panel
    3 Results
  • Door
    3 Results
  • Tub
    3 Results
  • Motor & Pump
    3 Results
  • Frame
    3 Results
  • Racks
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Troubleshooting

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Kenmore dishwasher Model #587.14012406A

A:

Dishwashers are a great time saver. I found some information for you that I am hoping will help you. I am adding the link below to help you with your question while you wait for your expert response. It may take 24-48 hours,. I do hope that this will help you with the dishwasher.

Read More
Marc -
September 21, 2012
A:

Thanks for choosing ManageMyLife to assist you. I researched the parts at the SearsPartsDirect.com web site. You requested prices for the solenoid and the pump and did not find a solenoid. I found the pump. It cost $47.66 Click here to view the mechanical drawing of the dishwasher and to order any required parts. I hope the mechanical drawing will be helpful.

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact your local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others. On something like this I recommend starting at the drain line under the sink. Pull the drain hose off of the garbage disposer or sink & place it in a bucket or pan. Close & latch the door & put the unit in a drain mode to see if you can get the water to drain out. Other diagnosing will require accessing the motor area & taking voltage readings. If the drain solenoid is receiving voltage you will hear the loud clunk of the plunger pulling in. When you hear the drain solenoid kick in, the water is discharged out of the pump into the collection chamber & then out to the sink. The problem could either be the collection chamber piston/nut is worn & failing or the drain solenoid is not activating. If the drain solenoid is operating & the drain line is clear & the unit is still not draining, you have an internal pump/motor failure or the drain hose is kinked somewhere between the dishwasher & the sink. If the drain solenoid is not engaging you will need to check the voltage to it. I would recommend that you have a technician diagnose and repair this. The testing can be complicated. If you would like to schedule service, just click on this link: Sears Home Service .

I hope this helps. If you need further assistance, please reply to this existing thread, just log back into the ManageMyLife. Go to the homepage,and your profile. This will direct you to your profile page. Scroll down to the bottom of your profile page until you see "(your name) conversations" Click on your question. you'll see "Join this conversation" from there, you can reply back, then Click "reply" This is the fastest way to talk to me. .

Read More
James -
Sears Technician
September 21, 2012
See more answers

Top Parts