Model #580761750 CRAFTSMAN Power Washer, Gas

Find part by diagram >

Question and Answers

Q:

580.761750 Unloader Help 580761750 Craftsman High pressure washer

Q:

Craftsman 4.0 HP Pressure Washer

A:

Pressure washers are a great power tool. Having to remove and replace spring your pressure washer can be a challenge without any instructions. I found a parts schematic/parts list. I am adding the link below to help you with your question while you wait for your expert response. I hope this will help.

Read More
Marc H -
March 26, 2012
A:

Thank you for your question on the location of the spring for the throttle on the pressure washer engine.

I have found a picture of a 10A900 engine series that may help you with the spring connections.

Pick one of the three styles you have.

I will send you a picture below that I hope will help you.

Sam A.

Read More
Sam A -
Sears Technician
March 29, 2012
A:

Thanks Sam A. the pictures were exactly what I needed. All is well.

Read More
John -
March 29, 2012
A:

Hi, Sam and others; I am having a problem with RE-INSTALLING THE TWO SPRINGS AND METAL LINK on the model # 10A902-233-01 B&s ENGINE. Sam, I looked at the three pictures that you posted above but they were way too small even when enlarged. Can you help me, please? Ros ros@netbox.com

Read More
ros -
August 11, 2015
See more answers
Q:

Crafysman Power Washer model # 580.761750 pump unloader cap removal.

A:

Having to remove and replace parts on your Washer can be a challenge without any instructions. While you are waiting on an expert to answer your question, a suggestion I have is to set service with a Sears technician so they can fix this Washer right away. I have attached the link below. Hope this helps!

Read More
Dezeray S -
July 18, 2011
A:

Thank you for your question.

The unloader cap is threaded into the pump housing. The image below show what the unloader cap looks like as one piece. The image came from OPE. Please reply below if you need further assistance. If the head of the plug has come off it will be difficult to remove. I have seen technicians cut along the inside of the plug in several places with a small saw blade. Then use a screwdriver to break it out. Just be careful not to cut into the metal housing. If this does not work, you have to replace the housing. Once you have the pressure washer repaired, I recommend using pump saver over the winter or during long storage. Please let me know if you need further assistance.

Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
July 19, 2011
See more answers

Top Accessories