Model #580753010 CRAFTSMAN Power Washer, Gas

  • Main Unit
    3 Results
  • Pump
    3 Results
Find part by diagram >

Question and Answers

Q:

pump oil is coming out the top of the breather tub 580753010 Craftsman Pressure washer

A:

Thanks for your question- we see that no one from the community responded.  If you still require assistance on this topic, please resubmit your question with any updated information and we will have one of our experts take a look.  Also, we have updated our site to include information regarding common repairs and diagnosis, which can be found here: www.searspartsdirect.com/repair-help.html.  If you are looking for your owner’s manual, it can be found here: http://www.searspartsdirect.com/partsdirect/user-manuals.  Thanks for visiting SearsPartsDirect.com.

Read More
Natasha12 -
Sears Technician
May 13, 2014
Q:

Change Carburetor in Sears Pressure Washer Honda Engine GC190AQHAD

A:

I can understand your desire for precise instruction on installing a carburetor. I was unable to locate instructions for your specific model number but the expert who reviews this question will likely be able to give you the instruct you need. I was able to find some torque specifications that I hope will be helpful in that these specs can sometimes be universal. Click on the link below to open the page. Though this link discusses a different model number, the mechanics are likely going to be very similar. Keep in mind that an expert will be responding within the next two business days if not sooner and will likely offer you more information and instruction. You will likely hear from them within a few hours. I hope this link will help you, in some way, and have a nice day.

Read More
Henry -
July 19, 2013
A:

Remove the air filter cover and air filter. Now you should see 2 screws that hold the carburetor in place behind the air filter base. There will usually be another (3rd) screw that secures the air filter base as well. Remove those 3 screws and lift the air filter base off of the engine the carburetor will be sitting right there. Take the fuel line off of the carburetor and then pull it out just a bit. Now you should be able to remove the linkage from the carburetor and take then the carburetor will come off the rest of the way.

Now you can set the new carb in place and connect everything back up in reverse. Do keep in mind how the gaskets are in place for the carburetor when you're taking the old one off as they will all need to go back in the same order.

Thank you for using Manage My Life!

Read More
Wade_B -
Sears Technician
July 22, 2013
See more answers
Q:

pressure washer pump oil

A:

I'm sorry that you are having difficulties finding clear instructions on the oil change issue with this tool. I did some research for you at managemylife.com and found an expert answer to a similar question that may assist you until your expert can respond. I have attached the link below. I hope it is helpful until your expert can respond.

Read More
James -
February 18, 2011
A:

Thanks James no help at all.

Read More
brad -
February 18, 2011
A:

Thank you for your question.

I can understand wanting to know how much oil to put in the pump.

If you purchased the oil for the pump from parts direct part number: BB3061BGS it is a pre-measured amount and you would put the whole bottle in.

If you purchased some after market bulk oil for pressure washers, fill the pump to within a 1/2 inch from the cap. That 1/2 inch will allow for expansion of the oil when it gets hot during operation.

I hope this will help.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
February 18, 2011
A:

great info... but where do you put it in>>>>

Read More
Tora -
May 26, 2011
See more answers

Top Parts

Top Accessories