Model #580752330 CRAFTSMAN Power Washer, Gas

Find part by diagram >

Question and Answers

Q:

need replacement fuel cap for power washer model # 580752330 580752330

A:

Replacement  fuel cap for power washer model # 580752330  is a Briggs & Stratton part number 796577.

Read More
Ernest7574 -
Sears Technician
November 02, 2015
Q:

Pressure washer will not start after using once 580752330 Craftsman Pressure washer

A:

Thank you for your inquiry on your Craftsman Pressure Washer, Model: 580.752330. From reviewing the details on your model, you need to decide if the problem is no fuel or no spark. Remove the spark plug and hold your finger or thumb on the hole the spark plug screws into. Get someone to pull the starter rope or engage the starter and the compression should push your finger off the spark plug hole. This will tell you the valves are operating inside the engine and you have compression. Pour a thimble full of fuel into the hole the spark plug came out of. Quickly install the spark plug and pull the starter rope or engage the starter. The engine should try to start. This would tell you there is a spark and the engine will run if you get fuel. If the engine doesn't try to start, pour another thimble full of fuel into the cylinder. Look at the anode of the spark plug and see if it is wet. Try to start the engine again. If it still doesn't try to start, remove the spark plug and connect the ignition wire to the spark plug. Hold the bottom of the spark plug to a clean area on the engine block. Use insulated pliers or gloves to hold the spark plug to prevent shock. Get someone to pull the starter rope or engage the starter and see if you get a blue spark from the anode of the spark plug to the base of the plug. If there is no spark the ignition module on the engine is bad. If you have spark the problem is in the fuel supply. Did you run the engine after draining the fuel to burn the fuel out of the carburetor? If not the carburetor will be clogged with the remnants of the old fuel and need to be replaced. If you ran the fuel out of the carburetor, the diaphragm or float is probably just dry and not flexing. You should take the carburetor apart and clean and soak the diaphragm with fuel or clean the float and needle and seat. The fuel line might be cracked and letting air into it stopping the fuel from feeding the carburetor.

Safety Warning: Before beginning the repair, disconnect the direct power supply to the pressure washer to prevent the risk of injury or any electrical shock.

If you don’t feel comfortable or confident in this repair, then you can have it repaired at home by a sears technician. I have the included a link to the website: Sears Home Services or call 1-800-469-4663.

I hope this answered your question. Thank you for contacting SearsPartsDirect.com, and have yourself a wonderful day. 

 

Read More
Gerry 93 -
Sears Technician
June 22, 2015
Q:

Pump oil capacity 580752710 Craftsman Pressure washer

A:

Thank you for choosing Sears Parts Direct. I will be more than happy to help with your pressure washer. Upon researching model580752710; based on the model number provided, this model uses pre-measured bottle of oil that is about 4.6 oz. I have posted a link of the pump oil to view the link click here

I trust this information will help you, we appreciate your business thank for choosing Sears.

Read More
CarlosZ -
Sears Technician
June 03, 2015

Top Parts

Top Accessories