Model #5648963600 KENMORE All Refrigerator

  • Replacement Parts
    3 Results
  • Accessories
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Broken Freezer Door 5648963600 Kenmore Refrigerator

A:

Thank you for choosing Sears Parts Direct. I can certainly understand how frustrating it can be when needing to replace the door your on your freezer. I did look into the model number you have provided and I do apologize I was not able to locate instructions due to the age of your product. Your unit is from 1987 so there are no instructions. 

Remove the top hinge and then the door can be lifted off the bottom hinge. Now remove the bottom hinge and you will need to make a shim to put behind the hinge. There is no part for this. A thin piece of cardboard will work. Replace the hinge and now you can reinstall the door.

Let me know if this helps.

You can also visit searpartsdirect.com for parts, diagrams, and repair information.
 
 
If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for your question. Have a great day.

Read More
Natasha12 -
Sears Technician
May 15, 2014
Q:

How to replace this evaporator?

A:

Normally, the lines have to be sweated loose with a torch. On some older units, the line may be able to be cut with a small copper tubing cutter. Reconnecting it will require a torch and solder. This is a job only a certified technician should perform. There is other special equipment for the freon that will be needed, that only a technician will have. I'm listing a site you can check to have a tech come out. Here is a link for the website: Sears Home Services . This is a very delicate and precise job that if not done correctly, will cause the compressor to fail.

Read More
Scott D -
Sears Technician
March 31, 2010
Q:

What needs to be done, to get the door to close, on this refrigerator?

A:

Most of the time when inner door liners are replaced the door has to be adjusted, to close properly. Sometimes it can be bowed back in place but most of the time, the screws holding the inner panel, have to be loosened. With the screws loosened, you can adjust the door as needed and then retighten the screws. Sometimes the door hinges have to be shimmed out slightly also. To shim the doors out, the door has to be taken off the unit. Remove the top hinge and then the door can be lifted off the bottom hinge. Now remove the bottom hinge and you will need to make a shim to put behind the hinge. There is no part for this. A thin piece of cardboard will work. Replace the hinge and now you can reinstall the door. Also make sure the drip tray is in properly and check if it can be adjusted. If the door still won't close, a technician may be needed.

Read More
Scott D -
Sears Technician
October 15, 2009

Top Parts