Model #536881650 CRAFTSMAN Snowthrower, Gas

  • Engine
    3 Results
  • Frame Assembly
    3 Results
  • Gearcase Assembly
    3 Results
  • Drive Assembly
    3 Results
  • Dischard Chute
    3 Results
  • Auger Housing
    3 Results
  • Handle Assembly
    3 Results
  • Chute Rod Assembly
    3 Results
  • Shift Yoke
    3 Results
  • Wheel Assembly
    3 Results
Find part by diagram >

Question and Answers

Q:

Snow thrower Tire Replacement 536.881650

A:

Thank you for choosing Sears Parts Direct. I will be happy to help with your snow thrower. Upon researching model number 536.881650; the bushing has been updated as well. The new tire would use the new bushing.

 Thank you for choosing Sears. We appreciate your business. Have a great day.

Read More
Jeff Wallace Jr -
Sears Technician
June 01, 2015
Q:

snow thrower won't start. 536.881650

A:

Thanks for the inquiry and for being a valued member.

In order to access the carburetor you will need to pull off the choke, and throttle knob. NOTE: Drain the fuel tank before servicing.

Remove the engine shroud by taking off the five screws using a 10 mm wrench. Disconnect the wire from the ignition switch and the primer line from the primer button. Slide the breather hose out of the heat box. Remove the two carburetor mounting nuts with a 10 mm wrench. Slide the heat box off the two carburetor mounting studs. 

With a full can of carb cleaner, a wire brush, and a bread tie wire to poke through and clean the main jet; I would recommend a very thorough cleaning. Start by taking off the float bowl. Douse it very liberally with carb cleaner, and undo the pin for the float, and remove the needle and float. Clean them very thoroughly with the wire brush and carb cleaner. Pay close attention to the seat the needle sits in and clean it well. Once clean, start brushing the carb bowl and body and make sure you get all the varnish out. It may take three or four brushings with carb cleaner dousing in-between. From there, take the straw of the carb cleaner and shoot carb cleaner through any little hole or passageway of the carb. Shoot out the throat of the carb and poke the main jet with the bread tie wire. You have to make sure you get everything the first time, if you leave anything behind, it’s likely to reclog once you have it reassembled. 

I hope this helps and thanks for using SearsPartsDirect.com. We appreciate your business. 

Read More
Jeff Wallace Sr -
Sears Technician
March 23, 2015
Q:

My snowblower engine fires but will not continue running. New spark plug, float bowl o ring, appears to b getting fuel. 536881650 Craftsman 6.5hp snow thrower

A:

Thank you for choosing Sears Parts Direct. I will be happy to help with your snow thrower. Upon researching model 536881650; the carburetor could need to be cleaned out. I might be getting fuel but if it’s not getting the proper air to fuel ratio it won’t run for long. Also check the air filter to make sure it’s not restricted.

Thank you for choosing Sears. We appreciate your business. Have a great day.    

Read More
Jeff Wallace Jr -
Sears Technician
December 23, 2014

Top Parts