Model #5204 IBM Computer

  • Covers
    3 Results
  • Paper Feed Asm
    3 Results
  • Electronics
    3 Results
  • Transport
    3 Results
  • Carrier
    3 Results
  • Carrier Shaft
    3 Results
  • Options
    3 Results
  • Paper Trays
    3 Results
  • Sheetfeed Covers And Cables
    3 Results
  • Frames
    3 Results
  • Attachment Plates
    3 Results
  • Block Assembly
    3 Results
  • Option - Envelope Feed
    3 Results
  • Sheetfeed Assembly
    3 Results
  • Plate Assembly
    3 Results
Find part by diagram >

Question and Answers

Q:

GOLDSTAR R5204 not blowing cold air R5204 Goldstar Room a/c

A:

Thank you for contacting SearsPartsDirect.com with your questions about your air conditioning. I am so sorry you are having problems with it. I know the air conditioning is a key component in our daily lives and know you want to get it working quickly. In this case I recommend you have this tested and repaired by a qualified technician. Internal components of the air conditioning can retain dangerous high electrical charges even when the air conditioning is disconnected from the power supply.

Here at SearsPartsDirect.com, we love to help you with your home repairs but in this case, for your safety, we recommend you have the air conditioning serviced. If you would like a Sears technician to complete the repair, you can set up service at www.SearsHomeServices.com or by calling 1-800-469-4663.

Thank you for your understanding in this matter. I hope we can help you with any future repairs. Thank you for choosing Sears, we appreciate your business.

Read More
Samantha A -
Sears Technician
May 14, 2014
Q:

Water dispenser inside refrigerator suddenly stopped producing water.

A:

I understand how it can be very frustrating when your water dispenser stops working. While you are waiting for your expert answer, I have found a link that will provide some information on the issue. I hope this helps.

Read More
aashe -
February 06, 2012
A:

The hum you hear is the solenoid on the water valve activating to let the water through to the dispenser. It sounds like the water reservoir for the dispenser might be frozen. You can try warming the water reservoir with a hair dryer to defrost it.

The water reservoir is located inside the housing where the dispensing lever is located. You can remove 2 screws from the bottom of the housing and drop the dispenser with the reservoir down from the top of the refrigerator liner.

You can go to Parts Direct and see a picture of the water reservoir. If the reservoir is frozen, adjust the refrigerator temperature slightly warmer to prevent refreezing.

Read More
Jimmy K -
Sears Technician
February 07, 2012
See more answers
Q:

need correct parts to convert range hood to non ducted type

A:

I understand that you want to convert your range hood to a non ducted range hood. While you are waiting for an expert to respond, I have attached some helpful links below that may provide information to assist you with your question. I hope the links that I provided are helpful. Have a great day!

Read More
Alina F. -
December 09, 2011
A:

The mounting bracket will not look exactly like the drawing shown in that installation guide. The first image below shows a photograph of that part. The part number for the mounting bracket is BE3344985. Here is a direct link for that part: Mounting Bracket .

You will need a recirculation kit (part B03300495) and the charcoal filter (part B03300488) to install this range hood without ducting to the outside of your home. The information for the original recirculation kit is shown in the second image below. The recirculation kit has been revised. I am not sure if the new kit will be installed exactly like the one shown below. The kit should come with instructions. This information should help you configure the range hood to recirc.

To install this range hood correctly, you should extend that decorative flue all of the way to the ceiling so that the top bracket can be properly installed. You will need to order and install an extension (part RFXN5204) for the non-ducted flue.

This should be the information that you need to properly install that range hood in a non-ducted manner to recirc the exhaust air into your kitchen.

If you need more help, reply with additional details and we will assist you further.

Read More
Lyle W -
Sears Technician
December 12, 2011
A:

I know its been a while but my parts were all on back order and i just received them. Could you please send instructions on how to convert the exhaust to recirculation air flow and how to mount the main hood to the wall. This item was bought at Sears scratch and dent with no manual...thks. Also, what is a "plenum" as indicated in the above diagram?

Read More
Lia -
January 18, 2012
A:

reference "plenum" I looked it up online and if that was something that is part of the conversion kit...I didnt get it...is this something I can buy at the big box store or another special order part from Sears?...(hope it wont take another month to get!!!)

Read More
Lia -
January 18, 2012
A:

I will need to check with the manufacturer about that plenum and the recirc kit instructions. I will update this thread as soon as possible. I added a link for the installation guide below this response.

Read More
Lyle W -
Sears Technician
January 18, 2012
A:

Okay. I contacted the manufacturer (Broan manufactures this range hood for Kenmore). They indicate that you will not need the part B03300495 but you will need the part RRK51 recirculation kit. It appears to be in stock through the Sears PartsDirect.com website. That kit is shown in the image below. The plenum is circled in red. That kit has the charcoal filter, the plenum and the reduction adapter. The manufacture indicated that the revised kit that is described above is no longer used on this range hood. I recommend that you return that recirculation kit part B03300495. You will not need that kit. You can keep the charcoal filter for later use or you can return it. The kit RRK51 will come with a charcoal filter as shown in the image below. I apologize for the inconvenience regarding this installation. If you need more help, let us know.

Read More
Lyle W -
Sears Technician
January 19, 2012
See more answers