Model #5079 PORTER CABLE Drill Driver

  • Right Angle Drive
    3 Results
Find part by diagram >

Question and Answers

Q:

One of the igniters keeps clicking even when knob is off 911 33359591

A:

Searspartsdirect.com is always a great resource to find the answers to your parts questions. Your Sears partsdirect expert will research your question and respond within two business days but usually sooner. Thank you for using Searspartsdirect.com!

Read More
Julio -
July 15, 2013
A:

Hello glad to help.  Thank You for choosing Sears PartsDirect.com

I am sorry and do understand your frustration when the igniter keeps clicking.   What is clicking is the spark module.   It is what ignites your burners and sounds to be going bad.  

I have included a link to our PartsDirect page where you can purchase the part you need to complete your repair. Just click the blue link below to be taken to the page.

http://www.searspartsdirect.com/partsdirect/part-number/WB13K5079/0022/364?pathTaken=directMatch&filterPart=&pop=flush&prst=0&shdPart=WB13K5079&sid=MMLxexpertmerch

If you have further questions please let me know.
Thanks for choosing Sears PartsDirect.com

 

Read More
Larry L -
Sears Technician
July 16, 2013
See more answers
Q:

Unit burners keep sparking with control knobs off 91133389890 Kenmore 36" gas counter unit

A:

Good morning... I can fully understand your concern regarding this issue. I did locate a link that will discuss your situation in greater detail. Though this link discusses a different model number, the mechanics are likely going to be very similar. Keep in mind that an expert will be responding within the next two business days if not sooner and will likely offer you more information and instruction. I hope this link will help guide you as to what might be wrong with your stove top and have a nice day.

Read More
Henry -
February 15, 2013
A:

Thank you for submitting your question. I understand your concern and I will be happy to assist you. First, the polarity of the power supply to the range should be checked for reverse polarity and also the ground circuit should be checked. Reverse polarity means that the line one voltage (L1) and neutral (N) is reversed. If any moisture or water boils over and runs behind the burner knobs it can cause the burner switch to short circuit and cause the igniter to begin sparking. Secondly, when any one burner knob is set to the "lite" position, all 4 electrodes/spark igniters should spark, not just one. In order for the spark igniters to begin sparking one of the four burner knobs must be turned to "lite" in order for the igniter switch to close and complete the power supply circuit to the spark module. The only other way for the igniters to begin sparking is when spark module has voltage supplied to it or if the polarity is reversed and there is a shorted wire somewhere between the burner switches and the spark module. I would check for moisture first. If there is no moisture than the issue will more than likely be with the spark module (WB13K5079). You can order parts from our Sears Parts Direct web site. Disconnect the gas supply line and lift the cooktop out of the cabinet to remove the top. To remove the maintop, remove the burner caps, grates, and burner knobs. Disassembly:

  1. Remove the control knobs
  2. Remove the screws securing the burner bowls to the burner.
  3. Remove the electrode wires from the electrodes.
  4. For glass top- Lift glass off the appliance
For porcelain top- Life up to top (hinged rear)
  1. Spark module is mounted to the burner box. Located in the rear right or left corner.

NOTE : For glass top units only. The rubber seal must be re-installed to prevent spillovers from seeping into the burner box bottom. I hope this information helps. Please reply back to this thread if you require further assistance with this repair. If you do not feel comfortable performing test or repairing this problem yourself, I recommend scheduling for service. You can schedule for service online with our Sears Home Services team. Thank you for using Manage My Life.

Read More
Tykara -
Sears Technician
February 15, 2013
See more answers