Model #4955 SOUND DESIGN Misc Audio

  • No Image Available - Fidelitone
    3 Results
Find part by diagram >

Question and Answers

Q:

Craftsman, aircompressor model number: 919.167244, blown heaad gasket

A:

The ManageMyLife website is a great place to find answers to questions that need qualified and insightful responses. Some of these questions that are asked will need specific research and will be answered by an expert with-in two business days but usually sooner.

Read More
Dezeray -
April 09, 2013
A:

Most likely if you replace the head gasket then the problem will be solved. It certainly sounds like that's all that's wrong with your compressor. Make sure to torque the head bolts to 49-55 inch pounds when you put everything back together. The head gasket is part number Z-D24819 and may be ordered from the link below.

Thank you for using Manage My Life!

Read More
Wade_B -
Sears Technician
April 11, 2013
A:

My question is more basic: I have removed the torx screws that hold the shroud, but I can't seem to remove the shroud. There are 4 rubber coated tabs that hold the base. I thought perhaps that the shroud could slide to one side enough so the tabs on one side would clear the shroud, but the shroud does not want to move. What am I doing wrong?

Read More
Daniel -
December 19, 2015
See more answers
Q:

Valve replacement guide 919156510 Craftsman Craftsman air compressor

A:

Thanks for the inquiry and for being a valued member.

To replace the valve plate you need to first unplug the unit from the wall. Then remove the plastic housing around the motor. Now you should be able to see the pump. Remove the four bolts that secure the head to the pump. Once they are remove you should be able to separate the head, valve plate, and cylinder. There is a gasket between these parts and could cause them to stick together. If they are stuck together, use a small flat blade screwdriver between the parts to separate them. After you take them apart, notate how the parts were orientated and clean the old gasket material off the mating surfaces. Now you can put the unit back together in the reverse order with new gaskets. Then torque the head bolts to 49-55 in/Lbs.

We apologize for the inconvenience with not having the pans, and we appreciate your business. Thanks for using SearsPartsDirect.com.  

Read More
Jeff Wallace Sr -
Sears Technician
December 22, 2014
Q:

how do I change out the valve plate? 919167260 Craftsman Air compressor

A:

I did some research on the unit and I was unable to locate information that would be helpful with regards to your question at this time. Your expert will answer within two business days with detailed information. Thank you for using Manage My Life.

Read More
Joseph P. -
February 06, 2013
A:

Thank you for your question.  I am sorry you are having a problem with the air compressor. To replace the valve plate you need to first unplug the unit from the wall. Then remove the plastic housing around the motor. Now you should be able to see the pump. Remove the four bolts that secure the head to the pump. Once they are remove you should be able to separate the head, valve plate, and cylinder. There is a gasket between these parts and could cause them to stick together. If they are stuck together, use a small flat blade screwdriver between the parts to separate them. After you take them apart, notate how the parts were orientated and clean the old gasket material off the mating surfaces. Now you can put the unit back together in the reverse order with new gaskets. Then torque the head bolts to 49-55 in.-Ibs.  I hope this is helpful. Please let me know if you need further assistance.  Thank you for using Manage my life. Mark

Read More
Mark T -
Sears Technician
February 07, 2013
See more answers