Model #49000 KENMORE Venting (Dryer)

  • Venting
    3 Results
Find part by diagram >

Question and Answers

Q:

taking out warming drawer of oven and replacing thermostat

A:

When it comes to replacing parts on your tool it can be tough without any instructions. While you are waiting on an expert to answer your question, I suggest you look over your model number and attach it to this thread so you can get a better answer from the experts! Have a nice day!

Read More
Dezeray -
May 09, 2012
A:

I did: Kenmore oven 665 758 49000--Thanks

Read More
Fredric -
May 09, 2012
A:

The procedure for removing that warming drawer is shown in the first image below. The second image shows the parts diagram for that portion of the range. You may not be able to access that thermostat for the warming drawer from the front of the range. You will probably need to access it from the back. Be sure that you unplug the range before accessing internal components.

I don't have a specific procedure for accessing that thermostat. You may be able that parts diagram and your personal observation of the components to remove that thermostat. If you need more help, reply with additional details and we will try to assist you further.

If you get to the point where you need to have a service technician access and replace that component, you can schedule service through this link: Sears Home Services .

Read More
Lyle W -
Sears Technician
May 10, 2012
A:

Thanks--I'll try to get to it tomorrow and let you know. fred

Read More
Fredric -
May 10, 2012
See more answers
Q:

How do I replace a thermostat on my Kenmore oven?

A:

This model of range does not have a thermostat; it uses a sensor probe called a temp sensor #43. You should be able to see the probe in the upper back section of the oven cavity. Some models you have to remove the rear panel to access the screws that mounts the sensor, others have the mounting screws inside the oven. Remove the sensor & unplug the wiring harness. Reverse procedure to re-install the new sensor.

Read More
biker dave -
Sears Technician
March 29, 2009
A:

I need to take out the warmer drawer of my Kenmore 665 758 49000 oven to replace a thermostat., I see 3 of them, and only one--a lower one--was sent-- Thanks in advance--Fred

Read More
Fredric -
May 09, 2012
See more answers
Q:

Why won't my car go past 4000 rpm when I floor it. It won't speed up past about 40 mph

A:

I know this type of information can be very helpful for you to have. While you are waiting for your expert answer, I did some research on the unit. I was unable to locate information that would be helpful with regards to your question at this time. Your expert will answer within 24-48 hours with detailed information. Thank you for using Manage My Life.

Read More
Priscilla V -
October 09, 2011
A:

Sounds like there is an issue with the trans not shifting properly or at all. Need to bring it in and have it properly diagnosed.

Read More
MikeLangton -
Sears Technician
October 22, 2011
A:

My sons car was doing the same thing,it was his muffler,we replaced it now its fine.If you want to self check bang on bottom of muffler with your hand if you hear anything rattling inside replace.Hope it helped.

Read More
Daddy 2 two -
November 10, 2011
See more answers