Model #46513339600 KENMORE ELITE Dishwasher

  • Front Panel
    3 Results
  • Frame & Lid
    3 Results
  • Tub
    3 Results
  • Wash System
    3 Results
  • Upper & Lower Dishrack
    3 Results
  • Accessory
    3 Results
Find part by diagram >

Troubleshooting

Question and Answers

Q:

Top drawer is leaking 46513339600 Kenmore Elite Kenmore dishwasher

A:

Thanks for your question- we see that no one from the community responded.  If you still require assistance on this topic, please resubmit your question with any updated information and we will have one of our experts take a look.  Also, we have updated our site to include information regarding common repairs and diagnosis, which can be found here: www.searspartsdirect.com/repair-help.html.  If you are looking for your owner’s manual, it can be found here: http://www.searspartsdirect.com/partsdirect/user-manuals.  Thanks for visiting SearsPartsDirect.com.

Read More
Natasha12 -
Sears Technician
May 13, 2014
Q:

The Kenmore Elite #46513339600 dishwasher�s top drawer will not drain.

A:

I see that you found the previous answer provided below. I replied to the details that you provided in that thread: Top drawer of my Kenmore Elite dishwasher model 435.1332 won't drain. I checked the coarse material trap and it was clean. How do you check the main drain?

That information should help you. Reply with additional details if you need more assistance.

Read More
Lyle W -
Sears Technician
January 11, 2011
A:

how do u get the drawer out from the front side

Read More
Wayne -
January 11, 2014
See more answers
Q:

dishwasher inlet bezel

A:

Reattaching parts can be harder than it seems. I located a previous post for this model with some diagrams and it does show the bezel. I attached below if you would like to check while waiting for directions from the expert. I hope this makes it a bit easier.

Read More
Barbara H. -
April 14, 2012
A:

There doesn't seem to be any information on this part. I believe just push in and turn to lock it in place. I'm not sure if it's CCW or CW you turn it. Let me know and Monday I can try to find out more.

Read More
Fred M -
Sears Technician
April 14, 2012
A:

Thanks for your response. I originally had the same idea but there don't appear to be any mating parts that would allow this. After getting a better picture of the tub, it is actually the air outlet bezel near the top of the tub.Any help will be appreciated. Thanks, Art

Read More
Arthur -
April 16, 2012
A:

Just to be sure. The bezels are shown in the image below. It is the upper one we're dealing with, correct? Let me know if we're both talking about the same part.

Read More
Fred M -
Sears Technician
April 17, 2012
A:

yes, that is the one (pictured with the glove) , I tried putting it in place and rotating it, but there dosen't seem that there are any mating parts unless something broke off. I did not find any loose parts in the tub

Read More
Arthur -
April 17, 2012
A:

If the seal in place? If something broke then it would be part of the tub. The tub would be cost to $100 dollars but check for the seal first.

Read More
Fred M -
Sears Technician
April 18, 2012
A:

Where would the seal be and what does it look like? Thanks, Art

Read More
Arthur -
April 18, 2012
A:

The seal/filter would be available from this site: [ Seal/Filter | http://www.searspartsdirect.com/partsdirect/part-number/99003715/0022/465&pathTaken=partSearch&blt=14&prst=0&shdPart=99003715 ] .

Read More
Fred M -
Sears Technician
April 18, 2012
A:

I was sure if the above link works so if not then try the link listed below.

Read More
Fred M -
Sears Technician
April 18, 2012
A:

I wasn' t ablt to bring up an image but the seal/filter may have the tabs needed to hold the bezel in place. Let me know when you get it.

Read More
Fred M -
Sears Technician
April 18, 2012
See more answers

Top Parts