Model #4441A EUREKA Vacuum, Upright

  • Agitator
    3 Results
  • Handle And Bag Housing
    3 Results
  • Model Notes
    3 Results
  • Attachment Parts
    3 Results
Find part by diagram >

Question and Answers

Q:

Dehumidifier 58054701700

A:

Air quality and comfort is so much better in a home with a dehumidifier. Keeping the units operating smoothly sometimes requires a little help and this is a great place to find help. While you wait for the expert, you can check a similar question from a previous expert post if you like. I attached the link below along with the copy of the owner's manual if needed. Hope this information helps.

Read More
Barbara H. -
April 03, 2011
A:

The answer Barbara H sent has good instructions for replacing the caster on your dehumidifier.

Our information does not show how the casters are attached. You will need to look and then follow the instructions that fit your model.

Read More
Jimmy K -
Sears Technician
April 04, 2011
See more answers
Q:

I'm trying to install a caster on my electric edger.

A:

When trying to install a caster on Electric edger can get a little frustrating especially with out a manual. While you are waiting on an expert to answer your question, I researched your model number in the Sears Parts Direct website and found a manual for Edger. I attached the link below. Hope this helps! http://www.searspartsdirect.com/partsdirect/part-model/Craftsman-Parts/Edger-Parts/Model-358796460/0247/1503400?pathTaken=

Read More
Dezeray S -
November 09, 2010
A:

To access and replace the swivel housing and arm, the machine case must be taken apart. The case halves act as the motor housing, meaning that the whole machine will have to be opened up. Because of that and the safety hazards involved, I have to recommend you have a qualified technician address this problem. The motor assembly must be taken apart and reassembled correctly in order to ensure safe operation.

You can go here: Sears Home Services to make arrangements to have your machine serviced by a professional.

Thank you for using Manage My Life!

Read More
XX Wade_ -
Sears Technician
November 10, 2010
See more answers
Q:

How do I install a replacement Caster on my Craftsman electric edger?

A:

I understand how inconvenient it is to have your edger not working properly and needing to replace a part. While you are waiting for an expert answer, I did manage to find a link that will provide you with more information about your problem. I hope my link is useful.

Read More
Joseph P. -
October 11, 2010
A:

I have attached the parts image of the front wheel assembly on your edger. The front wheel is held onto the axle with a push nut. Most push nuts are not re-useable once they are removed. I would recommend you get a new push nut as well.

There is no need to take about the assembly to change out the wheel on this model. If you do need to talk about that whole assembly, there are 2 screws that hold that assembly together.

You mentioned needing a shop manual for this model, they do not make nor publish a shop manual for these items. They put out the owner's manuals and part images and that's it. There is no other documentation that can be had. This has been a problem (in my opinion) for several years.

If you're just trying to replace the wheel though, it should be a cut and dry thing to remove that push nut and put the new wheel on and put a new push nut on.

Thank you for using Manage My Life!

Read More
XX Wade_ -
Sears Technician
October 12, 2010
See more answers