Model #435 HUSQVARNA Chainsaw, Gas

  • Accessories
    3 Results
  • Carburetor Zamac1t-el41
    3 Results
  • Carburetor & Air Filter
    3 Results
  • Chain Brake & Clutch Cover 435
    3 Results
  • Chain Brake & Clutch Cover 435e
    3 Results
  • Clutch & Oil Pump
    3 Results
  • Crankcase
    3 Results
  • Crankshaft
    3 Results
  • Cylinder Cover
    3 Results
  • Cylinder Piston
    3 Results
  • Fuel Tank
    3 Results
  • Handle
    3 Results
  • Ignition System
    3 Results
  • Muffler
    3 Results
  • Starter
    3 Results
  • Starter
    3 Results
  • Winter Kit
    3 Results
Find part by diagram >

Question and Answers

Q:

EW30EW55GS5

A:

Manage My Life is a great website to speak directly to an expert who can help you every step of the way to solving the problem you are having. An expert shall have an answer to your question within 24 to 48 hours. Have a great day.

Read More
Alina F. -
September 15, 2011
A:

According to your description, it is difficult to determine whether you have a component failure in the oven. Three hours of cooking time for pot pie does seem excessive unless it was frozen. The normal cooking time for most pot pies is 1 hour or less. The oven is apparently preheating properly according to your details. When you open the oven to insert the pot pie, the temperature will normally decrease. This may be why you are seeing 310 degrees when you start the convection bake mode. That oven has a hidden bake element that will normally take longer to raise the temperature in the oven. It takes some time to get used to that hidden bake element feature if you had a different type of oven and just replaced it with this one. Since the oven eventually reaches the 400 F cooking temperature, the bake element is probably okay. Check the broil mode to make sure that feature is working properly. If it is, then I recommend that you try various dishes in different rack locations in the oven to see if you have a definite problem with the bake element or the control. If the oven is malfunctioning, then I recommend that you have it serviced by a technician. If it is under warranty, I recommend that you follow the procedure in the manual for scheduling warranty service. You can call Electrolux at 1-877-435-3287. I hope that this information helps. If you need more assistance, reply with additional details.

Read More
Lyle W -
Sears Technician
September 19, 2011
A:

Good evening. I have an electric oven EW30EW55GS5. He is presenting the error f 15. Ja changed Range 8v electronic power supply board and FRIGIDAIRE Control-Electrical. When the machine is turned on the oven light comes on and after the error appears f 15. What should I do?

Read More
EMMANUEL -
August 09, 2015
See more answers
Q:

need wiring diagram for model 59676603601 59676603601 Kenmore Elite Bottom mount refrigerator

A:

Thank you for choosing Sears Parts Direct. I will be more than happy to help with your refrigerator. Upon researching model59676603601; I have posted an image below of the wiring diagram for this model.

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact your local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

 

I trust this information will help you, we appreciate your business thanks for choosing Sears.

Read More
CarlosZ -
Sears Technician
August 06, 2015
A:

I could not find the image of wiring diagram. Could you email it to me at daves435@aol.com

Read More
daves435 -
August 07, 2015
See more answers
Q:

won't go into reverse. use to pop out of reverse and grind to put back into reverse. 917293203 Craftsman Tiller

A:

Thank you for choosing SearsPartsDirect.com. I will be more than happy to assist you. I can understand any frustration you may have experienced with regards to your unit. Let’s see what we can do for you.

I'm showing there was an issue with the clutch control locking pin. I have information showing me that if this is encountered the phone number 1-800-435-3688 is to be contacted. When calling this number makes sure you have model and serial number ready. 

Hope this information has helped you. Again, thank you for choosing SearsPartsDirect.com.

 

Read More
JeffwallaceIII -
Sears Technician
April 20, 2015