Model #41799395100 KENMORE Laundry Centers/Combos

  • Drum And Heater
    3 Results
  • Motor And Blower
    3 Results
  • Control Panel
    3 Results
  • Top And Cabinet
    3 Results
  • Tub, Basket, And Agitator
    3 Results
  • Gearcase/transmission
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Hello, How do I replace the belt on my Kenmore stackable dryer, model 417.99395100?

A:

New belts often seem like they are going to be too small. I understand how difficult the process can feel. The expert will be able to provide the right instructions for your model. I did attach the schematics for the dryer from Sears Parts Direct so you can see how the belt would fit. Hope this helps while you wait for the expert.

Read More
Barbara H. -
September 02, 2010
A:

Pry the top ,it pops loose!unplug before even looking at it!!!!Inside unplug the elect connection to the front panel(Door&light switches) remove the knobs on the controls! I believe two screws by the lint filter possably a few more here&there! The whole drum rests on apoorly designed felt&plastic strip,which I'd replace now or You'll have to do this all again soon,as well as the ball&socket bearing that holds up the back of the drum(which is probably sqeaking by now) When you take the front off the drum will rotate downward and the belt is the easiest part to replace(it looks like a cheap rubber band)It's pretty easy,but after all the times I've done it it gets easier! Wait till the washer starts to go in the bag!!!! It starts with the loads banging around',the original shocks are junk(the replacements are much better constructed,if You don't catch them soon as possible the bearing goes bad and its part of the transmission(Costs as much as the washer! Start saving now,and buy another

Read More
Drew A Dyer -
September 02, 2010
A:

This type of repair will require accessing the dryer front panel & removing the rear inspection panel to remove the belt. I have provided you with complete step by step instructions with pictures to help guide you through the repair process. Please click on the link below for details. Remember to disconnect power to the dryer before attempting access.

Belt on stackable dryer broken how does it thread around the pulley?

Dryer drum belt;134503600 $18.49 www.searspartsdirect.com length 87.75", width 1/4"

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact your local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
biker dave -
Sears Technician
September 03, 2010
See more answers

Top Parts