Model #41794814301 KENMORE Laundry Centers/Combos

  • Upper Cabinet/drum/heater
    3 Results
  • Motor/blower/belt
    3 Results
  • Control Panel
    3 Results
  • Lower Cabinet/top
    3 Results
  • Motor/tub
    3 Results
  • Transmission
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Tune up kit for dryer 41794814301 Kenmore Laundry center

A:

Hello glad to help.  Thank You for choosing Sears PartsDirect.com
 
I am sorry and do understand your frustration when there is items needed for the laundry center.
 
Glad to help out.   Im  looking at your Kenmore Laundry Center model number  41794814301.
 
I am sorry but I cannot verify if there is a tune up kit for this model.  The part number  you gave looks like it would be sufficient because it is a Frigidaire part number and this model 41794814301 was built by Frigidaire and has the Kenmore name.
 
 
Please "RESUBMIT YOUR QUESTIONS IF THERE IS ANY OTHER PROBLEMS".
 
Thank you for your understanding in this matter and I hope we can help you with your future questions and repairs.  Thank you for choosing Sears and using our SearsPartsDirect.com.
 

Read More
Larry L -
Sears Technician
June 06, 2014
Q:

washer doesn't spin 41794814301 Kenmore Laundry center

A:

Thank you for your question and I understand your concern.

You failed to mention if the washer motor will operate or not in the agitation cycles or if the agitator is moving during the agitation cycles. If the washer will begin agitating after the washer is filled with water, then it does not have a broken belt. This model has a drive belt and not a motor coupler.

You also did not indicate if the motor is running or not after the drain pump drains all the water. If the motor does come on after it completes the drain period and the basket does not spin, it could have gear case failure or friction issue preventing the basket from spinning. If the motor does not come on after it fills with water or when it should spin, it could have a faulty lid lock assembly.

To access components under the tub, the front washer panel needs to be taken off. Look for a couple of screws at the bottom of the front panel. Remove the two screws and then pull the bottom of the front panel outwards at about 30 degrees and the panel should be able to be pulled down and off. NOTE: Disconnect the laundry center power cord from the power source before servicing.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.


Read More
Joey S -
Sears Technician
November 01, 2013
Q:

how can I change belt # 137292700 in kenmore Laundry Center? 417.94814301

A:

Searspartsdirect.com is always a great resource to find the answers to your parts questions. Your Sears partsdirect expert will research your question and respond within two business days but usually sooner. Thank you for using Searspartsdirect.com!

Read More
Julio -
July 19, 2013
A:

Thank you for choosing searspartsdirect.com.

I'm sorry to hear you are having problems with trying to change your belt, that can be a frustrating project.

I have provided step by step instructions for you on how to change that belt.

I hope this will help you with your project.

Read More
JessicaM -
Sears Technician
July 20, 2013
See more answers

Top Parts