Model #41793052201 KENMORE Residential Dryer

  • Cabinet/drum
    3 Results
  • Front Panel/lint Filter
    3 Results
  • Controls/top Panel
    3 Results
  • Motor
    3 Results
  • Burner
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

dryer won't stay lit 41793052201 Kenmore Sears/dryer

A:

Thank You for choosing Sears PartsDirect.com and being a valued member. It is unfortunate to hear that you are having issues with your dryer and I do understand your frustration. Glad to help out. I'm looking at your model number 41793052201 and from your description I would suspect an issue with the igniter itself or the gas valve is not releasing gases for ignition and this can be caused by a failing valve or the control board is not sending the proper signal to the valve to open. Here is a link for a video that will help test the igniter and the valve. Just click the blue link above to be taken to the page. I trust this information will help you.

 

Thank you for choosing Sears PartsDirect.com.

 

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact Sears for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Sherman_G_Wallace -
Sears Technician
October 31, 2014
Q:

My gas dryer 417.93052201 ignites but does not mantain 41793052201 Kenmore Sears/dryer

A:

Thank you for choosing SearsPartsDirect.com. I will be more than happy to assist you. I can understand any frustration you may have experienced with regards to your unit. Let’s see what we can do for you.

It sounds like the glow bar igniter is not getting hot enough to ignite the gas. I would suggest replacing that glow bar igniter, and see if this changes anything for you. 

Hope this information has helped you. If you are not comfortable doing this repair you can click here to schedule a technician or call toll free 1-800-469-4663. Again, thank you for choosing SearsPartsDirect.com.

 

Read More
Samantha A -
Sears Technician
October 27, 2014
Q:

Is it the ignitor that is bad on my Kenmore dryer model 417.93052201 that is running but won't heat?

A:

If the ignitor is glowing when the dryer will not heat then you likely have bad gas valve coils. An explanation of the heating circuit in this dryer is shown in the image below. I recommend replacing the gas valve coils since this is an intermittent problem.

You can order parts from the Sears PartsDirect website.

If you need more help, resubmit your question with additional details.

Read More
Lyle W -
Sears Technician
November 23, 2009
A:

To the helpful person who answered, this is a gas dryer. Any additional thoughts? It fires initially, but will not maintain.

Read More
meoryou -
November 20, 2009
See more answers

Top Parts