Model #41789690820 KENMORE Laundry Centers/Combos

  • Cabinet Parts, Heater
    3 Results
  • Console Controls, Drum
    3 Results
  • Dryer Motor, Blower, Belt
    3 Results
  • Tubs, Water Valve, Ltd Switch
    3 Results
  • Washer Drive System, Pump
    3 Results
  • Transmission, Water Seal, Lower Bearing Asmy.
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

How to replace washer drive belt 41789690820 Kenmore Washer/dryer

A:

Thank you for choosing Searspartsdirect.com and being a valued member. I can certainly assist you.

  • To remove and replace the belt on this washer you will need to gain access by removing the front panel on the washer.
  • There will be two screws in the front at the bottom of the panel and then slide the panel down and towards you to unhook the front panel from the side panels of the washer.

 

  • Once removed you should be able to see the belt and remove off the pulleys as shown in the picture below.


You can also visit searpartsdirect.com for parts, diagrams, and repair information.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for your question. Have a great day.

SAFETY NOTICE: Be sure to disconnect power to the unit before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact your local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Natasha12 -
Sears Technician
August 19, 2015
Q:

How to replace washer drive belt 41789690820 Kenmore Washer/dryer

A:

Thank you for choosing Searspartsdirect.com and being a valued member. I can certainly assist you.

  • To remove and replace the belt on this washer you will need to gain access by removing the front panel on the washer.
  • There will be two screws in the front at the bottom of the panel and then slide the panel down and towards you to unhook the front panel from the side panels of the washer.

 

  • Once removed you should be able to see the belt and remove off the pulleys as shown in the picture below.


You can also visit searpartsdirect.com for parts, diagrams, and repair information.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for your question. Have a great day.

SAFETY NOTICE: Be sure to disconnect power to the unit before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact your local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Natasha12 -
Sears Technician
August 19, 2015