Model #41769052990 KENMORE Residential Dryer

  • Page 1
    3 Results
  • Page 2
    3 Results
  • Page 3
    3 Results
  • Page 4
    3 Results
  • Page 5
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

what is the capacity of mt kenmore dryer model # 417.69052990

A:

Usually this information can be found in your owners manual. A simple way to locate your owners manual here on Manage My Life is by clicking on one of the top tabs that say "MANUALS" then typing in your model number in the search side box; your owners manual should be there for you to view. I have attached the link below for you to view. I hope the link that I have provided you is helpful.

Read More
Alina F. -
December 11, 2010
A:

I have the owners manual and this information is not given Nice idea though.

Read More
michelle -
December 11, 2010
A:

The capacity of this dryer is 5.75 cubic feet.

Read More
Fred M -
Sears Technician
December 11, 2010
See more answers
Q:

Why does my Kenmore model 417.9052990 dryer run in air fluff but won't heat and blows a fuse when it tries to heat?

A:

If the dryer will run in air fluff and only tries to blow a fuse when it tries to heat then most likely there is a short in the heating circuit.

A short can be a difficult thing to find and I'd suggest a technician check and repair this problem.

The short could be at the element, temperature switch, timer or a pinched wire somewhere in the harness.

If you feel comfortable with do-it-yourself the top can be raised with a putty knife. Remember to unplug the dryer first. With the top up you can see the hi-limit thermostat on top of the heater box.

The rear panel of the console can be removed as well to check for visible clues to the short such as burnt connector or a loose wire.

There is one thing to try if you're careful. The temperature switch has two wires on it. One thing to try is to remove both of the wires and tape them out of the way and plug the dryer back in and see if it still blows the fuse when it tries to heat.

If the fuse doesn't blow then most likely the temperature switch is the problem.

I'd still recommend a technician check this but if you make the checks you can submit another question with any additional details for further assistance.

Read More
Fred M -
Sears Technician
October 16, 2009

Top Parts