Model #41727182701 KENMORE Commercial Washers

  • Control Panel
    3 Results
  • Cabinet/top
    3 Results
  • Motor/tub
    3 Results
  • Wiring Diagram
    3 Results
  • Wiring Diagram
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Coin operated Kenmore front load just keeps running. 41727182701 Kenmore Washer

A:

Thanks for the information about the coin operated washer. Generally if a machine continues to run cycle after cycle without stopping it is the timer. However with the coin slide meter attached that could be the cause in your case. Unplug the coin slide meter and if washer stops continual running the slid meter is bad, if it still runs over and over the timer is most commonly the issue. If you need service here is the number to Sears Home services 1-800-469-4663.
Thanks Ron H.

Read More
Ron H -
Sears Technician
July 17, 2014
Q:

I need to know the water factor 41727182701

A:

Thanks for your question- we see that no one from the community responded.  If you still require assistance on this topic, please resubmit your question with any updated information and we will have one of our experts take a look.  Also, we have updated our site to include information regarding common repairs and diagnosis, which can be found here: www.searspartsdirect.com/repair-help.html.  If you are looking for your owner’s manual, it can be found here: http://www.searspartsdirect.com/partsdirect/user-manuals.  Thanks for visiting SearsPartsDirect.com.

Read More
Natasha12 -
Sears Technician
May 13, 2014
Q:

Commercial washer starts without inserting coins and runs for twice as long as the cycle should

A:

Having a coin operated washer that is starting without inserting the coins is bad for business. While you are waiting for your expert answer, I did manage to find a link that will provide you with some good information to help you with your question. I hope my link is useful.

Read More
Joseph P. -
August 20, 2011
A:

The problem with the long cycle times is often caused by a failure of the motor speed controller (a control board located next to the drive motor) to properly close the neutral side of the circuit through the timer motor. A service technician is normally needed to verify that diagnosis and replace the speed controller if necessary. Here is a link for the Sears Service website: Sears Home Services .

If you want to fix this problem on your own without further diagnosis by a technician, you can try replacing that speed controller (part 134149220) in one of your washers to see if that will fix the problem. Be sure that you unplug the washers before accessing internal components. Since you have several other washers that are the same model, you could replace the controller in the washer that is running long cycles with a controller from a washer that is working properly. If the washer works properly, then replacing that bad speed controller should fix your problem. If you still have the same problem, you can try replacing the timer with one from a good washer. One of those components is likely causing your long cycle times.

You can order parts for the washer from the Sears PartsDirect website.

The problem with the coin box will normally need to be repaired by a service technician. You can call Greenwald for help with that coin box. The phone number for Greenwald is 1-860-526-0800. Here is a link for that website: Greenwald Industries.com

If you need more help, reply with additional details and we will try to assist you further.

Read More
Lyle W -
Sears Technician
August 23, 2011
See more answers

Top Parts