Model #41516220 KENMORE Grill, Gas

  • Gas Grill
    3 Results
Find part by diagram >

Question and Answers

Q:

Kenmore Gas grill part

A:

Needing to replacing parts on your appliances can be really frustrating especially when it cost money. While you are waiting on an expert to answer your question, a suggestion I have is to visit Sears Parts Direct website to order your parts. I have attached the link below. Hope this helps!

Read More
Dezeray S -
April 18, 2011
A:

Thank you for your question.

I can understand needing the correct parts to fit your grill.

I think the part you are referring to is the carry over tube that goes from on burner to the next.

The carry over part number is: 7000278 and the burner number is: 7001802 and all of these can be purchased from:Sears Parts Direct .

If this is not the part you are referring to please let me know and I will research.

I hope this will help.

Thank you for using Manage My Life.

Read More
Sam A -
Sears Technician
April 19, 2011
See more answers
Q:

I have a model 415.16220 Kenmore grill. I lost the pal nuts for the carryover tube. Do I need these for the burners to work?

A:

I don't think the pal nuts will cause the center and right burner to not light. You should buy some new pal nuts at a hardware or building supply or a Sears store to replace them. If the crossover tube is out of position the center and right burners won't light.

Disassemble the grill far enough that you can see the crossover tube and light the left burner. The crossover tube should be burning a flame at the center and right burners. The crossover tube might be clogged or have some large holes in it that stop the gas from going all the way across.

Read More
Jimmy K -
Sears Technician
August 31, 2009
Q:

Why does my Kenmore Gas grill, quantum series regulator, quit working? I replaced it 3 times in 3 yrs.

A:

About 5 years ago the government passed a law concerning the shut off valve used in LP tanks and in gas grill regulators. The valves on the LP tanks and the regulators for gas grills must contain a safety shut off that will stop or severely restrict the amount of gas that can flow if a line breaks. This safety shut off causes many regulators to be replaced.

Sometimes air gets trapped inside the lines in the grill and the air can cause the safety in the regulator to shut down. If you remove the regulator from the tank, it will usually reset in 5-10 minutes and work ok. Leaving the burner valves on the grill open and turning the grill off and on with the valve on the tank can cause a shut down.

If you have any of the regulators you replaced, try them on the grill. Some or all of them might work.

If you turn the grill on and can just get enough gas to light one burner very low, turn the valve on the tank and the burner valves off. Remove the regulator from the tank and let it set 5-10 minutes and try it again. If the safety had tripped it will work now.

Read More
Jimmy K -
Sears Technician
May 26, 2009

Top Parts