Model #40752301210 KENMORE Dehumidifier

  • Dehumidifier
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

How can I get a circuit diagram or repair manual for model # 40752301210 Dehumidifier? 40752301210 Kenmore Dehumidifier

Q:

Dehumidifier stops working 40752301210 Kenmore Dehumidifier

A:

Thank You for choosing Sears PartsDirect.com and being a valued member. It is unfortunate to hear that you are having issues with your dehumidifier and I do understand your frustration. Glad to help out. I'm looking at your model number 40752301210 and if the compressor and fan are running something is wrong in the sealed refrigerant system. If the compressor is not running the problem is in the compressor, run capacitor, or the control board. These parts have to be tested with a volt/ohm meter. The bucket must be in the correct position for the unit to work. The compressor and fans must be working. If there is humidity then I suspect the problem is with the compressor or even the sealed system.  The humidity in the room might be lower than the setting on the dehumidifier. The compressor on the dehumidifier might not be running or there can be a problem in the sealed refrigeration system. Try setting the humidity lower on the controls. Be sure the temperature around the dehumidifier is not below 65 degrees. I trust this information will help you.

 

Thank you for choosing Sears PartsDirect.com.

 

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact Sears for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Sherman_G_Wallace -
Sears Technician
November 17, 2014
Q:

Attached hose to my Kenmore Dehumidifier is not gravity draining. What can I do?

A:

Managemylife.com is always a great resource to find the answers to just about anything. Your expert will research your question and respond within two business days but usually sooner.

Read More
Alina -
March 21, 2013
A:

Thank you for your question. I'm sorry you are having this problem with the dehumidifier. Make sure the drain line does not have any kinks and has a good downward slope to it. If this is ok and water is still getting in the bucket, it could be a problem with the drain pan under the evaporator. It may have a crack or the drain hole may be restricted. I would recommend having a technician check this. I'm listing a site you can access, for the nearest repair center. Here is a link that will provide the nearest drop-off locations:  Sears Home Services.  

Read More
Scott D -
Sears Technician
March 22, 2013
A:

I purchased a new unit and hooked up a new hose and still the water goes to the drain bucket. Does this mean that the unit is defective and the water pathway inside the unit is blocked? What is the fluid pathway for the water coming from the dehumidifier and how does it detect that a hose is attached. I am confused how the water is diverted if a hose is attached versus not attached? The drain connector nozzle does not have a plug when a hose is not attached?

Read More
Robert -
August 01, 2013
A:

Robert, this is kind of difficult to explain but basically, without the drain hose connected, when there is free air flow through the hose connection, the water will be diverted down to the drain bucket. When the hose is connected, there is a negative drawing effect that pulls the water out through the hose. Now, if the hose is longer than 10 feet and if it does not have a good downward slope, the water can back up and cause the bucket to fill. I hope this helps you.

Read More
Scott D -
Sears Technician
August 02, 2013
See more answers