Model #40082450 KENMORE Mixer- Hand

  • Replacement Parts
    3 Results
Find part by diagram >

Question and Answers

Q:

Question about Kenmore Mixer model number 400.82450 400.82450

A:

I know how important it is to have a good working mixer in the home so that you can mix up some great cakes. I did some research and I was able to find a link with a similar question. I hope this helps with your mixer troubles while you wait for your expert response.

Read More
Joseph P. -
October 31, 2012
A:

Dear Joseph, thanks for your reply. However, I don't have or see your link. Could you please send it again? Thanks again.

Read More
Lyndon -
October 31, 2012
A:

Thank you for your question on the stand mixer that has stopped running.

You are correct in that if there are parts needed to repair the mixer they are no longer available.

This mixer was made by Hamilton Beach for Kenmore.

Check with a volt/ohm meter to see if the plug for the mixer has power at the end of the cord. Also check the prongs in the power receptacle to make sure they are making contact with the power cord.

Internally there is not a lot you can do, unless you take is apart to see if there is a broken wire.

Thank you. Sam A.

Read More
Sam A -
Sears Technician
November 01, 2012
A:

Dear Sam A: sorry for the late reply and your reply. I took my mom's mixer apart and found out what's wrong. On the speed dial there is part that attaches to the speed dial inside the mixer. This plastic part has a peg on it that goes into a hole in a cam the regulates the motor's speed. The peg that goes into the cam hole broke off. Unfortunately this part is no longer available. I'm fairly handy I have to think about what I'm going to do to replace this peg. I've never had much luck with glues, so I'll have to go another route. Again thank you for your reply.

Read More
Lyndon -
November 18, 2012
A:

Thank you for the update on the mixer that has the pin on the speed control governor broken. I have experienced that on many older models. You may want to find some hard plastic material or some phenolic material if you can find a piece and fashion a new pin from it. It is amazing what you can do with a Dremel tool. The best of luck, and I think you will be able to fix the mixer. Sam A.

Read More
Sam A -
Sears Technician
November 19, 2012
A:

How do you disassemble this area to get to the peg?

Read More
Ron -
March 21, 2013
A:

Ron, I am sorry we do not have a repair manual for this model. I searched online for other postings for repair manuals. I did not have any luck there either. You must rely on your own observation of how the unit comes apart. If you run into problems, please send me an image of the area you are having problems with and I will be happy to look at them. Once I see the set up I should be able to assist you. Thank you for using Manage my life. Mark

Read More
Mark T -
Sears Technician
March 22, 2013
See more answers