Model #4000 BOSCH Saw Table

  • Table Saw
    3 Results
Find part by diagram >

Question and Answers

Q:

By-pass of water filter #9999 11015942401

A:

Thank you for contacting Sears. I will be more than happy to assist you with your Kenmore refrigerator.

I can understand the frustration of your refrigerator not functioning properly, after researching model number 253.70313214. the part number for the bypass plug is part number 242294402. This is available on our website at SearsPartsDirect.com below.

Click here.

I hope you found this information useful. Again thank you for choosing Sears. We appreciate your business, have a great day.

*Safety disclaimer before you try and repair the unit make sure the power supply is disconnected. There may be sharp parts to the unit that can cause injury to you if not careful. If you don’t not feel comfortable checking this yourself you can request a technician by visiting www.SearsHomeService.com*

Read More
Benny23 -
Sears Technician
July 08, 2015
A:

"Expert" huh... so the bypass plug is not included? Lame. You recommend we unplug the refrigerator before removing the filter and installing the plug? Really? Sharp parts? Sears ain't what it used to be. I came here for help with what now appears to be a very problematic refrigerator. The "expert" responses have more canned answer fluff than actual troubleshooting. I've been a life-long Sears customer, spending thousands upon thousands over the years. No more, I'm done being scammed out of any more of my hard-earned money.

Read More
Scott -
January 26, 2016
See more answers
Q:

caftsman lawn tractor 917.288562 (hrdrostatic auto trans) clutch/brake pedal pulses +/- 1 inch while engine is running; idle or moving

A:

It does sound like there are adjustments to be made. The expert will review and provide advice for this issue. I did locate a similar post if you care to check. I attached below. I also added the owner's manual if you do not have one.

Read More
Barbara H. -
June 09, 2012
A:

Thank you for your question.

I am sorry you are having a problem with the tractor. If the clutch pedal is jumping up and down, the problem is most likely a chunk missing out of the belt or a burnt spot on the belt. I recommend inspecting the entire length of the belt for defects. If the belt is fine check, all the pulleys for something stuck in them. If you need to order a replacement part, you can do so from the following link.

Read More
david -
June 26, 2012
A:

David,

I am glad to hear you have the tractor up and running. If this happens, again I recommend checking for binding in the clutch system. If it binds, the belt might not tighten up and burn.
Please let me know if you need further assistance.
Thank you for using Manage my life.

Mark T.

Read More
Mark T -
Sears Technician
June 27, 2012
A:

I am having a very similar problem as David. I need to change the drive belt also, however I cannot enlarge the information you attached to your response earlier. Can you please send that information to me, so I can get my tractor going again?

Read More
CHUCK -
November 19, 2015
A:

Sears repairman install new starter on DYT 4000 on 11/24/15. Started it up today for the first time and when I engaged the rotary blade, it blew a fuse. I replace the 20a fuse and repeatedly it blew a fuse and shut down each time I pulled the button to engage the rotary blade.

Read More
Joseph -
November 28, 2015
See more answers
Q:

My Maytag washer MAH400AWQ its spin but cloth still dam wet? What is the part do I need to replace MAH4000AWQ Maytag Washer


Top Parts