Model #3995 CRAFTSMAN Winch

  • Unit
    3 Results
  • Bracket Assembly
    3 Results
Find part by diagram >

Question and Answers

Q:

Why is my ice maker not making ice?

A:

Having ice during the holiday is almost a necessity in most home. I did some research at managemylife.com and found an excellent article that I hope will shed some light on the problem until your expert can assist you. I attached the link below.

Read More
James -
December 15, 2010
A:

I would first remove the ice bin and look or feel inside the mold of the icemaker to see if it is full of ice. If the ice sensing arm is down (in the on position) and the icemaker is full of ice, there is a failure inside the icemaker and the icemaker should be replaced. The part number for a replacement icemaker is WR30X10093 and the cost is $128.94. You can order parts at [www.partsdirect.com?sid=MMLxexpertxmerch].

If there is no ice in the icemaker, look at the fill tube on the rear of the icemaker. If the fill tube is frozen up the icemaker can't fill. You can defrost the fill tube with a hair dryer. If the fill tube freezes again you should replace the water valve.

The water valve on the rear of the refrigerator supplies water to the water dispenser and the icemaker. Since the water dispenser is working, the only line that could be blocked runs up the back of the cabinet and attaches to the fill tube for the icemaker. The water valve could be bad and not sending water to the icemaker.

Read More
Jimmy K -
Sears Technician
December 16, 2010
A:

I checked there is no ice in the mold and the arm is down.

Read More
rduri -
December 16, 2010
A:

The tube in the back looks and feels frozen---It's very hard. How much for a water valve, and is it difficult to replace?

Read More
rduri -
December 16, 2010
A:

The water valve is mounted in the compressor compartment on the rear of the range. The water line from the house plumbing attaches to the water valve. To replace the water valve, turn the water off at the valve. Remove the 2 screws holding the water valve to the cabinet. Remove the incoming water line and the 2 outgoing lines. Disconnect the wires from the 2 solenoids. Be sure to put the wires on the new valve in the same order they were removed. This is pretty easy and should not take long. Before replacing the valve, melt the ice out of the fill tube and wait 24 hours to see if the icemaker makes ice. There might be something wrong inside the icemaker instead of the valve.

Read More
Jimmy K -
Sears Technician
December 16, 2010
A:

I forgot the valve part number and price. The part number of the water valve is WR57X10051, and the price is $40.77. You can order the valve at www.partsdirect.com?sid=MMLxexpertxmerch.

Read More
Jimmy K -
Sears Technician
December 16, 2010
A:

Ok, I finally had some time and did as you suggested, however, after removing the ice bin and getting a much closer look, I believe the tube was not frozen. I used a hair dryer anyway just to make sure. I then took a look at the valve which does look easy to replace. I also found my parts manuel for this refrigerator (refrigerator purchased Aug 1997). The manuel gives a part number of WR57X0119 which is different from the part number you gave me. I also noticed a number stamped on the water valve, WR57X111. Which number do I use to place an order???

Read More
rduri -
December 17, 2010
A:

The original part number for the water valve was WR57X0119. The part number has changed to WR57X10051. Remember the problem can also be the icemaker. You can test the water valve by swapping the wires on the water valve solenoids. Open the freezer door and hold the light switch plunger in, press a glass against the cradle for water. If the water runs into the icemaker, the water valve is good and the icemaker is bad.

Read More
Jimmy K -
Sears Technician
December 17, 2010
A:

Thanks for the information. I did not switch the wires on the solenoid. I did order a new water valve. I figure the unit is almost 14yrs old and putting new water valve in is not a bad thing. If this does not work, it has to be the ice maker itself, correct? What is the part number for that?

Read More
rduri -
December 17, 2010
A:

The part number for a replacement icemaker is WR30X10093 and the cost is $128.94. I hope the water valve solves the problem.

Read More
Jimmy K -
Sears Technician
December 17, 2010
See more answers
Q:

Microwave model 665.61709100 runs all time F6 shows in display

A:

Manage My Life is a great website to speak directly to an expert who can help you every step of the way to solving the problem you are having. An expert shall have an answer to your question within 24 to 48 hours. Have a great day.

Read More
Alina F. -
September 22, 2011
A:

The error code F6 indicates a failure with microwave relay.

In some cases the error code F6 can be cleared by performing a hard reset.

1.Turn off the power to the Microwave for about 60 seconds. You can do this by doing a hard reset or unplugging the power cord from the wall. After waiting the 60 seconds return power to the microwave and check to see if the error code has been cleared. If this procedure does not solve the problem, contact a technician for full diagnostic.

Note: General resolution for problem is based on information submitted with question. If problem persist, contact a service technician.

Read More
Jerome G. - Personal Solutions Manager -
Sears Technician
September 22, 2011
A:

F6 means you have a shorted cook relay on the control circuit board. You can order the board, part number 8169699R (or just 8169699 - "R" means a remanufactured board) from the Sears Parts Direct Web site (1st link below) for $95.99. At the Web site in the second link, we have a video available showing how to remove a typical over the range control panel assembly in under 5 minutes. Then you unplug the keypad (as per the first photo below), make sure to unlock and remove the relay connectors (second photo) and then swap circuit boards in your frame. Or we can repair your board for $39.95. Details on that are also at the second link.

Read More
MicrowaveDisplaycom -
October 05, 2011
See more answers
Q:

Online birthday cakes

A:

Birthday cakes for loved ones in a different location is a great way to stay close. There are a surprising number of sites. I attached three links below to yummy looking cakes. Some like the one on the third link do state they use local bakeries which is a good way to be assured of freshness. I hope one of these helps you to say Happy Birthday.

Read More
Barbara H. -
January 29, 2011
A:

For something as special as a birthday cake, I recommend looking at Bake Me A Wish . This site allows you to browse through delicious gourmet birthday cakes. The cakes start at $39.95 with a 2 day shipping price of $9.95. I find this site to be the most creative and reliable. I definitely think you should check it out.

Read More
Korinna S -
Sears Technician
January 31, 2011
See more answers