Model #39719501 CRAFTSMAN Grinder

  • Split-phase, 115 Volts, 60 Cycle, 3450 R.p.m.
    3 Results
Find part by diagram >

Question and Answers

Q:

Need wiring diagram for Sears 397-19501 grinder

A:

Manage My Life is here to help! The experts will definitely be able to provide you with some information about your owners manual. It usually takes about 24-48 hours to receive a response. Have a great day!

Read More
Jackie S -
June 27, 2011
A:

We don't have a wiring diagram for your grinder. Look closely on the switch terminals. The terminals are usually marked line and load. This will tell you how to wire the switch.

If you have questions reply on this thread and I will be glad to help. If you can send images of the switch terminals, I will be glad to help.

Read More
Jimmy K -
Sears Technician
June 27, 2011
A:

The switch only has two terminals. That is not a problem. The grinder motor has four wires. Black, Red, White, Green. There is also a square block wired into it as well. Not sure if it is a relay or capacitor. Green=Ground, White=Return, Black and white normally are Line. Not sure on Red or Black Don

Read More
Donald -
June 27, 2011
A:

Donald, I suspect the square block is a capacitor. I am sending you a schematic of a different model bench grinder. See if this will give you some idea where to put the wires. Does the motor have a terminal block? Were all the wires disconnected or only the one to the switch?

Read More
Jimmy K -
Sears Technician
June 27, 2011
A:

How do I get the diagram you sent? I see nothing attached to your message. Don

Read More
Donald -
June 27, 2011
A:

Donald, I apologize, the image should have been on the bottom of the thread. I am sending it again.

Read More
Jimmy K -
Sears Technician
June 28, 2011
See more answers