Model #37-070 DELTA Jointer/Planer

  • Table
    3 Results
  • Guard/housing
    3 Results
Find part by diagram >

Question and Answers

Q:

Missing or misleading info on parts diagram 37-070 Delta 6" bench jointer

A:

I apologize for the apparent mistake by the parts representative. I looked at the table part 901394 that was substituted for the original part 1345882. That part only includes the out-feed table. The infeed support is part 1345883. 

Read More
Lyle W -
Sears Technician
June 03, 2014
A:

Are you saying that these are two different parts? Or what is the difference between 1345882 and 1345883? I just placed an order a few hours ago. Now I am wondering if I have two out-feed tables. The parts diagram only shows one table and one number.

Read More
Tim -
June 03, 2014
See more answers
Q:

My Delta 37-070 jointer will not turn on. Any thoughts to why or if replacing switch might help?

A:

The ManageMyLife website is a great place to find answers to questions that need qualified and insightful responses. Some of these questions that are asked will need specific research and will be answered by an expert with-in two business days but usually sooner. I did some research at Managemylife web site and found an expert answer to a similar question that may help until your expert can respond. I have attached the link below so you can check it out.

Read More
James -
May 12, 2012
A:

Thank you for your question on the jointer/planer that will not turn on.

If you have power to the outlet that the planer is plugged into then it should run when you flip the switch on.

On this model you have an on/off switch and a speed controller board and a motor.

It could be anyone of these three parts that have failed.

The first thing I would suggest is that you unplug the jointer and then plug it back in and try it.

Sometimes the control boards have a reset built in and unplugging sometimes will reset the control board.

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact your local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

If you feel comfortable with using a volt/ohm meter you will need to check for both voltage and continuity.

If that does not solve the problem you will need volt/ohm meter to check for voltage an input to the on/off switch and the speed control board. If you have voltage into the board but the motor will not run then I would say that you will need to replace the control board.

You can also check the switch for continuity with the meter set on the ohm scale and then turn the switch on and off to see if the switch is working.

Please let me know what you find out and we can continue to troubleshooting with that information.

Sam A.

Read More
Sam A -
Sears Technician
May 15, 2012
See more answers