Model #37048 MURRAY Walk Behind Lawnmower, Gas

  • Handle
    3 Results
  • Mower Housing
    3 Results
  • Mower Housing Page 2
    3 Results
  • Wheel And Tire
    3 Results
  • Grass Bagger
    3 Results
  • 22" Self Propelled
    3 Results
  • 22" Self Propelled Page 2
    3 Results
  • Handle
    3 Results
  • 20" Rotary Mower Complete
    3 Results
  • 20" Rotary Mower Complete Page 2
    3 Results
  • 20" Rotary Lawn Mower
    3 Results
  • 20" Rotary Lawn Mower Page 2
    3 Results
  • 22" Roatary Lawn Mower
    3 Results
  • 22" Roatary Lawn Mower Page 2
    3 Results
  • 22" Rotary Mower
    3 Results
  • 22" Rotary Mower Page 2
    3 Results
  • Gear Case
    3 Results
  • Edger-frame And Handle
    3 Results
  • Edger-frame And Handle Page 2
    3 Results
  • Cutting Head
    3 Results
  • Attachments/ Replacement Blades
    3 Results
Find part by diagram >

Question and Answers

Q:

REPLACE BATTERIES ON 247.37048 247370480 Craftsman Rotary mower

A:

I have attached 2 page below to help you with the cover removal on your mower. This is information direct from the manufacturer on it. I've yet to have one of these come into the shop so I can take some actual photos of the procedure.

Thank you for using Manage My Life!

Read More
Wade_B -
Sears Technician
October 23, 2013
A:

I cannot believe how effective this site is. Two responses with photos promising to show how to do this that are too small to see, and one claiming how wonderful it is and says nothing.

Read More
vance -
April 09, 2014
A:

I just found this information and think it'll be way more useful than what you were given. You will need a flat head screwdriver and some wood wedges. The motor shroud has four slots on the cover, two on each side. 1.) Place the flat head screwdriver into one of the four slots in the cover. 2.) Push in the tab behind the slot with the screwdriver while lifing on the cover at the same time to release the tab. 3.) Place a small wooden wedge under the cover so that it doesn't lock back into place. 4.) Do this on all four slots to fully release it. It might be best to go Front Right, Front Left, Rear Left, and then Rear Right. Good luck!

Read More
Kendra -
July 10, 2014
See more answers
Q:

Replace battery on rechargeable lawn mower

A:

Replacing the battery on a mower could be difficult sometimes.  While you are waiting for an expert to respond, I have added a helpful link that may provide information to assist you with your question.  I also added the owners manual.  Hope this helps!

Read More
Yadira B -
May 13, 2013
A:

Thanks for contacting Manage my life about your mower model 247370480, I will be glad to assist you with this issue. I have attached an image below that has instruction on removing the battery pack cover.Just click on the image to enlarge. I hope this helps, if you need additional help please reply with added details and I will be happy to respond. Here is a link to order any parts you may need. Sears Parts DirectIf you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link: Sears Home Services. Ron H.

Read More
Ron H -
Sears Technician
May 15, 2013
A:

I can not see the answer to how to remove the shroud to replace my batteries

Read More
Steve -
August 09, 2013
A:

Try this link - http://www.managemylife.com/images/35437/original/247.37048_battery_shroud_removal_process.jpg?1368613848

Read More
Anonymous -
August 09, 2013
A:

Steve, if you are not viewing this on the Manage my life web site you will not be able to view the image. Go to WWW.Managemylife.com. Ron H..

Read More
Ron H -
Sears Technician
August 09, 2013
A:

I just found this information and think it'll be way more useful than what you were given. You will need a flat head screwdriver and some wood wedges. The motor shroud has four slots on the cover, two on each side. 1.) Place the flat head screwdriver into one of the four slots in the cover. 2.) Push in the tab behind the slot with the screwdriver while lifing on the cover at the same time to release the tab. 3.) Place a small wooden wedge under the cover so that it doesn't lock back into place. 4.) Do this on all four slots to fully release it. It might be best to go Front Right, Front Left, Rear Left, and then Rear Right. Good luck!

Read More
Kendra -
July 10, 2014
See more answers
Q:

Question about Charging of Craftsman Battery Mower 247-37048

A:

I know how important it is to have a good working Mower in your home so that you can keep your grass maintained. While you are waiting for an expert answer, I did manage to find a link that will provide you with some good information about what may be causing your problem.

Read More
Priscilla V -
March 29, 2011
A:

There should be LED's lit if the unit is charging. It's very possible that the batteries have been damaged from sitting without any type of maintenance charge during that time. If the mower was stored over 2 months without having the charger put on during that time it is very likely the batteries have failed.

Plug the charger in and let it sit for 24hrs and see if anything with the indicator changes. If not, it's a very good possibility that the batteries have failed. I have run across a few of these with loose connections at the battery packs, so that's something to keep in mine. You may want to check the battery pack connections then charge for 24hrs to see if anything will change.

Thank you for using Manage My Life!

Read More
XX Wade_ -
Sears Technician
March 30, 2011
A:

I too have the same charger that came w/ my mower (model #18A-188-799 - MTD Mower). I have not been able to figure out how long to recharge it after use to get it fully charged. Is this a 'smart' charger that can be left on or do I need to unplug it after a certain period? I've not been able to locate any information on line and the manual only states to charge it for 14hrs before initial use. Seems that for $88 it should be smart enough to not overcharge the batteries.

Read More
Anonymous -
May 15, 2011
A:

the manufacturer states in the manual(page 11) that a "full 14 hour charge is always recommended".

Read More
XX Wade_ -
Sears Technician
May 16, 2011
A:

my batteries were without a charge for a long time and now will not charge all the way, I have ordered and received new batteries but can't get the top off to install them. Can someone please tell me how to get to the batteries. I have pushed in the tabs and tried to take it off but it feels like something is going to break if I pull any harder.

Read More
Greg -
May 30, 2012
A:

I am sorry you are having a problem with removing the shroud. I know it can be tricky to remove the cover. The manufacturer has come up with a set of instructions for accessing the batteries. Click on the image below to view the instructions. I hope this is helpful. Please let me know if you need further assistance. Thank you for using Manage my life. Mark.

Read More
Mark T -
Sears Technician
May 30, 2012
A:

yes, thank you that was very helpful, I have had these batteries for a week or more and could not find the answer so I finally called sears to get a return number to just send them back and finally found someone that told me about this web site, thanks again.

Read More
Greg -
May 30, 2012
A:

Greg, I am glad to hear the information was helpful. Please keep us in mind next time something around the house gives you problems. Have a great day. Mark

Read More
Mark T -
Sears Technician
June 01, 2012
A:

I have the 18A-188-799 mower. The first time out this spring it worked. It rained last night and I think the charger and mower got wet. Now it won't charge: When I plug in the charger, there's a faint green blinking light. When I plug it into the mower, it continues to slowly blink green. How do I know if it's the charger or the battery?

Read More
Gene -
May 24, 2014
See more answers