Model #3684 PEERLESS Faucet

  • Two Handle Washerless Mini Widespread Lavatory Faucets
    3 Results
Find part by diagram >

Question and Answers

Q:

Ref 1067697482. Want to remove icemaker permanantly. It will not run without it. What do I need?

A:

The icemaker can normally be disabled, by sliding the knob in the front, to the off position. If the icemaker is still working, it can be removed and replaced with a defrost timer # GA1005. This will be a timer only and it will take the place of the icemaker. It's available at SearsPartsDirect . The connection should be just like the icemaker connection in it now. It should also have instructions included. If you need more assistance, you can resubmit your question with more details.

Read More
Scott D -
Sears Technician
December 02, 2009
A:

Scott I have the same situation with kenmore model 106.8609580 with ice maker model 106.628384R. Would I need a defrost timer and is it the same one you recommended to jh3684 in your reply 2/12/09?

Read More
larry -
December 12, 2012
See more answers
Q:

Replacing freezer blower motor on refrigerator

A:

Wow having an appliance to least this a very great appliance. While you are waiting on an expert to answer your question, I was searching in the Sears Parts Direct website and found your diagram. I have attached the link below. Hope this helps!

Read More
Dezeray S -
January 22, 2011
A:

Being able to replace some parts yourself can save a lot of money. To replace this motor will require, taking everything out of the freezer, so the back panel can be removed. First disconnect power to the refrigerator. I�m attaching a picture with instructions to remove the icemaker. With the back panel out, you will be able to see and remove the motor. Disconnect the wires to the motor and remove the 2 screws holding the motor in place. Now you can drop the motor out of the shroud (# 12 in picture) and take the motor out. Pull the fan blade off of the shaft and then push it on the new one. Be sure to pay attention to the position of the blade on the original shaft, so you can put it back in the same place, on the new shaft. Now, place the motor back in place and secure it with the 2 screws. I hope this will help you. If you would like more assistance, any additional details will be helpful and I will be glad to assist you further. Thank you for using Manage My Life.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Scott D -
Sears Technician
January 24, 2011
See more answers