Model #3639557752 KENMORE Side-by-Side Refrigerator

  • Freezer Door
    3 Results
  • Dispenser
    3 Results
  • Fresh Food Door
    3 Results
  • Freezer Section
    3 Results
  • Freezer Section
    3 Results
  • Ice Bucket
    3 Results
  • Fresh Food Section
    3 Results
  • Fresh Food Section
    3 Results
  • Unit
    3 Results
  • Icemaker Wr30x0318
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

New ice maker, no power to water valve.

A:

Thank you for your question. I'm sorry you are having this problem with the new icemaker. If the icemaker was just installed, it's always recommended to allow at least 24 hours before determining, if the icemaker is not working. If it has been this long and there is still no water in the icemaker, a good check will be to manually advance the icemaker to see if it will fill toward the end of the cycle (see image). If you can hear a humming sound toward the end of the cycle but no water fills the icemaker, it indicates the valve is being energized but is not opening. In this case the water valve # WR57X10051 will need to be replaced. If water does fill the icemaker, it will indicate the icemaker is not cycling. This could be caused if the freezer is not getting cold enough (below 12 degrees). In this case, usually adjusting the cold control to a colder setting, will correct this problem. If the icemaker cycles but does not fill and there is no sound from the valve, some voltage checks will need to be made. If you have a meter and feel confident that you can safely make a voltage check and would like more assistance, reply to this thread and I will be glad to assist you further.

Read More
Scott D -
Sears Technician
August 28, 2013
A:

Good morning, I found out later, that the original problem, was no water to the ice maker. The old ice maker was defective, it had broken parts in the control box. The freezer is working just fine. I did check for voltage at the water valve, and it was 0 volts. The other side of the valve, that sends water to the dispenser is ok. You can fill a glass up with water.

Read More
Brian -
August 28, 2013
A:

Brian, I'm glad you discovered the problem and I hope the new icemaker is working. Thank you for using Manage My Life.

Read More
Scott D -
Sears Technician
August 29, 2013
See more answers
Q:

Water from dispenser tastes bad

A:

Managemylife.com is a great place to find the answers to just about anything, especially on appliances. I would suggest that you provide the detailed model number so your expert will be able to provide you the best possible answer. Just click on reply below and the provide the required data.

Read More
Priscilla V -
June 26, 2011
A:

Sorry, model number is 3639557752

Read More
Barry -
June 26, 2011
A:

I think you might want to empty your ice bucket completely also and clean it out. If you don't use much ice from your automatic ice maker, after a while it begins to take on a nasty flavor from leftovers and other things in your fridge. Maybe this could also have an effect on your water flavor as well. It is worth a try. We have had some trouble with that before with a Sears fridge. And we kept our filters cleaned and changed regularly. Just a thought? Good luck!

Read More
kelly -
June 26, 2011
A:

Thanks Kelly. Unfortunately the bad tasting water is without any ice. But we do dump the ice out regularly too.

Read More
Barry -
June 27, 2011
A:

I'm sorry you are having this problem with your water. Unfortunately, this model does not have a water filter. The most common reason for this type of problem is from a plastic water supply line. If the water supply line to the refrigerator is plastic, it will need to be replaced with a 1/4" copper water line. I also recommend replacing the reservoir behind the crispers inside the refrigerator because it can absorb the odor in the water. The reservoir # WR17X4358 and a copper tubing kit # 978567 are available at SearsPartsDirect . I hope this will help you. If you would like more assistance, any addtional details will be helpful and I will be glad to assist you further.

Read More
Scott D -
Sears Technician
June 28, 2011
See more answers

Top Parts