Model #3639532753 KENMORE Side-by-Side Refrigerator

  • Freezer Door
    3 Results
  • Dispenser
    3 Results
  • Fresh Food Door
    3 Results
  • Freezer Section
    3 Results
  • Freezer Section
    3 Results
  • Ice Bucket
    3 Results
  • Fresh Food Section
    3 Results
  • Fresh Food Section
    3 Results
  • Unit Parts
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Ice maker

A:

The Refrigerator is one of the most important appliances in the home and by far a must need. So I am understanding your concern over the issue that is currently happening. I have researched your issue on this website and came across a question that is similar to yours. The expert provides further detailed information that might enlighten you. Hope this helps!

Read More
Priscilla V -
December 30, 2012
A:

Thanks for the information about your ice maker; sorry you are having this issue.
Ice makers are very temperature sensitive and the freezer must maintain about 0 to 5 degrees before the ice maker will cycle by itself. The slightest variation of temperature can stall the production so it is vital that you allow at least 24 to 48 hour of non- interruption.

If you feel the temperature is correct and have allowed plenty time to cycle, then I would say you would need to exchange the ice maker.

Thanks Ron H.
If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link: Sears Home Services .

Read More
Ron H -
Sears Technician
January 02, 2013
See more answers
Q:

ice dispenser flap keeps opening and closing on its own.

A:

I'd be happy to advise you on this issue. Sears Parts Direct.com is an excellent place to find parts and have them shipped to your front door. There is only a couple of reasons for this to happen. I have provided a link below that will briefly discuss this. The technician in the link discusses having someone come to your home for the repair. But if you're knowledgeable, you may be able to do the work yourself. If not, then, certainly consider Sears Home Services to assist you. I hope this link is helpful and have a nice day.

Read More
Henry -
September 27, 2012
A:

Thank you for your question. I understand your concern about the flapper door. The most likely reason for this to happen will be due to a defective module. Replacing the module # WR55X130 should resolve this problem. It�s available at http://www.searspartsdirect.com/partsdirect/part-number/WR55X130/0046/363?pathTaken=directMatch&filterPart=&pop=flush&prst=0&shdPart=WR55X130&sid=MMLxexpertxmerch . To replace the module, remove the front cover. To remove the cover, use a small screwdriver and pry the bottom of the cover loose. It will be tight but it will pry loose. Be sure to disconnect the power first. With the cover off, you will have access to the module. Remove the knobs and disconnect the wire harness. Now, remove the screws holding the module to remove it. Reverse the procedure to install the new module. I hope this will help you. If you would like more assistance, reply to this thread and I will assist you further.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Scott D -
Sears Technician
September 28, 2012
See more answers

Top Parts