Model #3639504784 KENMORE Side-by-Side Refrigerator

  • Freezer Door
    3 Results
  • Dispenser
    3 Results
  • Fresh Food Door
    3 Results
  • Freezer Section
    3 Results
  • Freezer Section
    3 Results
  • Ice Bucket
    3 Results
  • Fresh Food Section
    3 Results
  • Fresh Food Section
    3 Results
  • Unit
    3 Results
  • Icemaker
    3 Results
Find part by diagram >

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

Instructions to remove and replace refrigerator door

A:

I'm real sorry to hear that you are having some difficulties with your Kenmore Refrigerator. I did some research for you at Managemylife and found an expert answer to a similar question that may help until your expert can respond to your specific question. The link is attached below. If you do decide to schedule service and have a qualified technician help you, I have also attached a link to Searshomeservices. I hope these links provided assist you.

Read More
James -
December 27, 2011
A:

I should have said that the water line runs through the bottom hinge. I believe that I need to disconnect that nylon line below the hinge, remove the door (screws at top, lift out of bottom hinge), replace the cams, and reverse. Correct?

Read More
Jim -
December 27, 2011
A:

Thank you for your question. I see you have determined how to remove this door. You are correct. Be sure to turn the water supply valve off first and also turn the refrigerator off or disconnect the power. With the water line disconnected and the screws removed from the top hinge, the door will lift up and off of the bottom hinge. If the water line will not fit through the hinge, it may need to be cut. In this case, replace the connection with # 2300868 if it's a 5/16" water tube or use connection # W10277958 if it's a 1/4" water tube. I hope this will help you. If you would like more assistance, reply to this thread and I will be glad to assist you further.

Read More
Scott D -
Sears Technician
December 28, 2011
See more answers
Q:

kenmore ice maker water won' shut off

A:

Any ideas?

Read More
Tamy -
January 12, 2011
A:

Having an appliance not to work properly can be quite a challenge to figure out what's wrong with it. While you are waiting on an expert to answer your question, I found this great link in the Manage My Life website and why ice maker won't shut off. I have attached the link below. Hope this helps!

Read More
Dezeray S -
January 12, 2011
A:

I'm sorry you are having this problem. The information you have received is good but is for a different type of problem. This type of problem is usually caused by a stuck water valve but it could also be from a short in the icemaker or wires. A quick check will be to turn the water back on and if the water starts flowing, disconnect power to the refrigerator. If the water stops flowing, it will indicate a short but if it continues, the water valve # WR57X10051 will need to be replaced.

Sometimes when the water has been turned off and there is no pressure on the valve, it may close. In this case, no water will flow when it's turned back on. The next time the icemaker cycles and fills, if the water continues to flow, now disconnect the power to see if it's a short or stuck valve. I hope this will help you. If you would like more assistance, any additional details will be helpful and I will be glad to assist you further. Thank you for using Manage My life.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Scott D -
Sears Technician
January 13, 2011
See more answers
Q:

What is causing this frost build-up at the chute?

A:

Air leaks in the recess area will be causing this type of frosting. The most likely sources of air leaks are:

  1. Through the cradle sleeve openings in the recess housing
  2. Between the recess housing and the outer door
  3. Through the wiring harness and water tubing conduits in the door.
To properly seal all possible sources of air leaks into the freezer door there is a recess icing kit that should be installed. There are 2 kits available:
  1. WR49X0343 white recess
  2. WR49X0344 black recess
These kits are available at PartSelect . This kit can be difficult to install and I would recommend having a technician install it.

Read More
Scott D -
Sears Technician
June 18, 2009