Model #36315651891 KENMORE Dishwasher

  • Escutcheon & Door Assembly
    3 Results
  • Body Parts
    3 Results
  • Motor-pump Mechanism
    3 Results
Find part by diagram >

Troubleshooting

Error Codes

Error Code:

Condition:

Check/Repair:

Question and Answers

Q:

How do I remove/replace the lower wash arm assembly/hub on my Kenmore dishwasher, model # 36315651891, part # wd22x10008.

A:

Managemylife.com is always a great resource to find the answers to just about anything. Your expert will research your question and respond within two business days but usually sooner.

Read More
Alina -
November 17, 2012
A:

The dishwasher is mounted with a reverse thread. I believe you can reinstall the spray arm without using the tabs. The replacement spray arm is part number WD22X10008. The image below may be helpful to you.

Read More
Fred M -
Sears Technician
November 17, 2012
See more answers
Q:

Kenmore dishwasher will not drain

A:

I understand how important it is to have all of your appliances working properly. While you are waiting for your expert answer, I have found two links that will provide some information and troubleshooting for the problem. The first is a basic troubleshooting and the second is a little more indepth. If you are not comfortable with doing any of this, then you may want to schedule service. I hope these help.

Read More
Anne -
September 27, 2011
A:

There are some things you can check if you don't mind doing a little do-it-yourself.

From the description you give I assume the dishwasher will wash okay but it won't drain.

On this particular dishwasher the motor doesn't reverse direction to drain out.

The timer will send voltage to the drain solenoid, see 2nd image below, to energize the solenoid. The solenoid is pulled down which opens a flapper in the sump to direct the water out the drain.

You can remove the lower access panel to see if this happens in drain. You should hear and see the solenoid pull down. It will activate with a snap.

If nothing happens then the timer or solenoid is not working. The solenoid can be checked for continuity if a meter is available. An open circuit, no continuity, would indicate a bad solenoid.

I hope this helps and thanks for the question. You can reply with any additional details for further assistance.

Read More
Fred M -
Sears Technician
September 29, 2011
See more answers

Top Parts