Model #3627595990 KENMORE Free Standing, Gas

  • Burner Section
    3 Results
  • Main Top Section
    3 Results
  • Cabinet
    3 Results
  • Door
    3 Results
Find part by diagram >

Question and Answers

Q:

oven bake mode not working

A:

I understand how frustrating it can be to have an oven bake mode not work properly. While you are waiting for an expert to respond, I have attached some helpful links below that may provide information to assist you with your question. Have a great day!

Read More
Alina -
August 11, 2012
A:

Thank you for your question and I understand your concern.

If the glow bar bake igniter is not glowing, the oven will not heat. It could have a faulty/broken igniter, oven thermostat or oven gas valve. Also; make sure your not selecting "Timed" bake if your have clock timer with a Start and Stop knob. If the igniter is not glowing, the igniter should be the first thing to check. It can be disconnected and tested for continuity with an Ohm meter. NOTE: Disconnect the power cord from the power source before removing the oven bottom and flame spreader.

Check the things I have covered here and if I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
August 13, 2012
See more answers
Q:

I need a wiring diagram for a kenmore gas range model 362.7595990

A:

Getting a hold of a wiring is determine also by the age of the range, I have attached some links below to Sears websites that can be helpful to you while you wait for the experts response. Hope it helps!

Read More
Maira -
November 30, 2010
A:

Been there, done that.

Read More
Terry -
December 01, 2010
A:

Please click on the attachment below for the information you requested on finding the wiring diagram for your Kenmore gas range.

Remember to disconnect power to the range before attempting access.

Parts can be ordered from; searspartsdirect

Read More
biker dave -
Sears Technician
December 01, 2010
See more answers
Q:

How do I replace the ignitor on my oven?

A:


You should access the burner and ignitor from inside the oven. Removing the oven door will make it easier to work. The oven door should lift off the hinges.
1.Remove the two screws holding the oven bottom in place and remove the oven bottom.
2.Remove the wing nut holding the flame spreader to the bake burner and remove the flame spreader.
3.Remove the screws holding the ignitor to the side of the bake burner and gently pull the wires to the ignitor through the back wall and into the oven.
4.Reverse these instructions to install a new ignitor and reassemble the oven.

Read More
expert -
Sears Technician
January 08, 2008
A:

The igniter I need to replace is the top burner, not the oven. Good info, though.

Read More
CONSTANTINOPLE -
October 03, 2010
See more answers