Model #36275889891 KENMORE Free Standing, Gas

  • Burner Parts
    3 Results
  • Control Panel & Cooktop
    3 Results
  • Body Parts
    3 Results
  • Door & Drawer Parts
    3 Results
Find part by diagram >

Question and Answers

Q:

I have a kenmore gas range model 362.75889891. The oven is not working and displaying an error message F4.

A:

Error codes are a way of knowing what is wrong with the appliances, like the Kenmore range. I hope the link provided below is helpful while waiting for an expert response.

Read More
Anna T -
October 09, 2012
A:

I know that it can be very difficult to have issues with your range. The F4 error code indicates that the oven control board detects a shorted oven temperature sensor probe or shorted sensor circuit. This could be caused by a failed temperature sensor, a melted plug or wiring connection on the probe or the wires in the temperature sensor probe circuit both being shorted to the cabinet of the range. The oven temperature sensor probe will need to be removed from the back wall inside the oven cavity and the resistance will need to be measured using an ohm meter. You should measure about 1100 ohms of resistance at room temperature when measuring the resistance across the two wire leads of the oven sensor probe. If not, then the probe will need to be replaced. If you don't feel comfortable doing this yourself, just click on this link to schedule service: Sears Home Services . I hope this helps. If you need further assistance, please reply to this thread. Thank you for using Manage My Life.

Read More
AnneJ -
Sears Technician
October 10, 2012
A:

I just replace the temperature sensor today and turn on the oven. It is still displaying the F4 error code. Is there any parts that are still not working? Thank you, Roberto

Read More
Roberto Borromeo -
October 25, 2012
A:

There are only three parts that control this function. The probe, the control board and the wiring harness. Since you have already replaced the probe, then the issue is either the board or the harness. It is most likely the control board causing this. I would suggest that you check the connections to the probe first. You will want to test the pins that plugs the probe into the board. If you are not getting the testing values mentioned above, then replace the board. If you are getting these, then replace the wiring harness. Please let me know if you need anything else. Thank you for using Manage My Life.

Read More
AnneJ -
Sears Technician
October 26, 2012
See more answers
Q:

Stove Repair

A:

Keeping the stove working is very important. I did some research but was not able to find an answer for your question. Your expert will be able to help give you a detailed answer. It may take 24-48 hours for your expert to respond. I do hope everything works out with the stove.

Read More
Marc H -
July 01, 2012
A:

Thank you for your question and I understand your concern.

If it was just the red lever that has fallen off from the stem, there is small pin that would slide through on side of the lever and then through the lever and the other side of the lever. The pin holds the red lever to the plunger. If you can find the pin, you should be able to slide the pin back through in order to reconnect the lever to the plunger. You may have to pull the metal plunger out a little in order to align the openings and slide the pin through the lever and plunger. See image below.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
July 03, 2012
See more answers

Top Parts

Recommended maintenance parts & accessories

Show 3 more
No more item to show