Model #3627586590 KENMORE Free Standing, Gas

  • Burner Section
    3 Results
  • Main Top Section
    3 Results
  • Cabinet
    3 Results
  • Door
    3 Results
Find part by diagram >

Question and Answers

Q:

oven not working 3627586590 Kenmore 30" freestanding gas range

A:

The Managemylife web site is a good resource of information to find out what may be happening and what options are available to you. I'm sorry to hear about the difficulties with your Kenmore 30" freestanding gas range. I did some research at Managemylife website and found this expert answer to a similar question that may help until your expert can respond. I have attached the link below so you can check it out. I hope this helps William.

Read More
James -
January 01, 2013
A:

Thanks for the question about your range not working after using the self-clean feature. Sorry to hear you are experiencing this issue.

The self-clean operation is stressful due to the high heat and amp draw during the cycle. It is very possible that a component has failed or that a wire or terminal has burnt off. I recommend that you check for the wiring issue behind the back panel and control cover area.
Always disconnect power supply before servicing the appliance and when testing live voltage be sure to wear proper safety equipment (gloves and eye protection) also be aware of sharp metals on product

Testing components will require special equipment and tools and a basic knowledge of electronic and electrical systems. I do recommend calling for service if you cannot find a wiring problem.

I hope this helps you find and solve the issue, if you need additional assistance please reply with more details and I will be happy to respond.

Thanks Ron H.
If you get to the point where you need to have a service technician diagnose and repair this failure, you can schedule service through this link: Sears Home Services .

Read More
Ron H -
Sears Technician
January 03, 2013
See more answers
Q:

lower over temp Kenmore gas range model 3627586590

A:

I'm sorry to hear that you are having some difficulties with your gas range, especially if the correct temperature is not being reached to properly cook your food. I did some research for you at Managemylife.com and found an expert answer to a similar question that may help until your expert can respond to your specific question. The link is attached below. If you do decide to schedule service and have a qualified technician help you, I have also attached a link to Searshomeservices.com. I hope these links provided assistance for you.

Read More
Joseph P. -
November 21, 2011
A:

The oven sensor is located on the rear wall of the oven. It is a stainless steel tube about 1/4 inch in diameter. You can remove 2 screws and pull the sensor into the oven for testing with an ohm meter. I am sending you a table of the resistances at different temperatures. Disconnect the wires from the sensor before testing. Disconnect the power to the range before removing the sensor.

Read More
Jimmy K -
Sears Technician
November 22, 2011
See more answers