Model #36275786890 KENMORE Free Standing, Gas

  • Burner Parts
    3 Results
  • Control Panel & Cooktop
    3 Results
  • Body Parts
    3 Results
  • Door & Drawer Parts
    3 Results
Find part by diagram >

Question and Answers

Q:

Kenmore oven blows my fuse at the plug.

A:

Having issues with your oven can be frustrating. you will receive a detailed rreply from an expert within 24-48 hours.

Read More
Priscilla V -
July 25, 2011
A:

Thank you for your question and I understand your concern.

Based on your symptom and details it sounds like there is a wire shorted to ground or Neutral or possibly a shorted electrical component inside the range. It could also have shorted wire inside the electrical outlet.

Finding a shorted wire to ground or a shorted component will require first making a visual inspection of all the wires in the range. Usually there would be a blackened area where the wire has touched and shorted to the metal chassis or ground.

I highly suggest calling a technician to locate the short and repair your range. It will require removing the top, control panel and oven bottom to check and test the components for shorts. It may require an ohm meter also. I highly recommend calling a service technician because it can be difficult removing the small screws around the surface burners. The screws must be removed before the top can be hinged opened and the screws are prone to twist off. Reply back if you feel confident in repairing your range yourself and then I'll provide the basic tear down instructions.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Joey S -
Sears Technician
July 27, 2011
A:

Thank you so much. We would greatly appreciate the tear down instructions.

Read More
Mary -
July 30, 2011
A:

Mary: I provided the only instructions available in the image below. I hope this helps you. I recommend calling a service technician to diagnose and repair your range. Removing the little screws from the burner heads can be difficult and can easily be twisted off or broken. These screws must be removed before the top can be hinged open. Being a gas range there should not be too much wiring to check.

Read More
Joey S -
Sears Technician
August 02, 2011
See more answers

Top Parts