Model #36275381890 KENMORE Free Standing, Gas

  • Burner Parts
    3 Results
  • Control Panel & Cooktop
    3 Results
  • Body Parts
    3 Results
  • Door Parts
    3 Results
Find part by diagram >

Question and Answers

Q:

Kenmore Oven 362.75381890

A:

It is important to have the correct information on conversions for the Kenmore range.  In the owner manual it states that the conversion instructions, sticker and LP orifices can be found attached to the range next to the pressure egulator, and there is a second set of instructions included.  An expert will respond with additional information within two business days, usually sooner.  Thanks for your patience. 

 

Read More
Anna T -
April 24, 2013
A:

That LP conversion should be completed by a qualified installer.


I posted the instructions for LP conversion in the first image below. The regulator will need to be converted to LP gas. The adjustments for the oven burners are shown in that first image. I posted additional details about the adjustments for the oven burners in the second image. That should help the installer convert the range to LP gas.


If you need more assistance, reply with additional details.

 

You can contact your local gas provider for a qualified installer if necessary. You may also be able to find a pre-screened service provider on the ServiceLive.comwebsite. 

Read More
Lyle W -
Sears Technician
April 25, 2013
A:
Lyle W -
Sears Technician
April 25, 2013
See more answers
Q:

Why won't the bake cycle work on my gas stove model 362.75381890 even though it will heat in the clean cycle?

A:

You could have a weak igniter on the bake burner. The clean cycle will likely heat since the broiler burner and the bake burner are both used in this mode. I recommend that you pull the oven floor out and remove the flame spreader. Start the oven in the bake mode and see if the igniter will glow. The first image below explains the operation of the burner ignition circuit. If the igniter is glowing but the burner will not light then the most likely failed component is the igniter since its resistance is not decreasing enough to allow enough current to flow through the safety gas valve to that it will open for ignition. You can verify that this is the failed component by unplugging the range and switching the broil and bake igniters since they are the same part. If the bake burner ignites properly after switching the igniters then replacing the bad igniter will fix your range. The part number for the igniter is WB13K21 (NOTE: If your igniter has a MALE connector then you will need part WB2X9998). You can also connect the igniter with ceramic wire nuts if necessary.

If the igniter is not glowing at all it could still be bad. You can try switching it with the broil igniter as described above to see if it will glow. If not, then you could have a failed control board or a wiring failure in the bake ignition circuit. An failed gas valve could cause this problem but that type of failure is rare.

These tips should help you determine the cause of your oven failure so that you can repair it yourself. If you need more help, resubmit your question with additional details.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Lyle W -
Sears Technician
February 03, 2010
Q:

Why does the bake flame cycle On and OFF repeatedly?

A:

The likely failure is a weak oven ignitor. If the ignitor does not pull enough current/amperage the oven gas valve will not stay open. Ignitor part# WB13K21 (See image below)

Read More
Joey S -
Sears Technician
April 02, 2009

Top Parts