Model #3627536891 KENMORE Free Standing, Gas

  • Gas & Burner
    3 Results
  • Cooktop
    3 Results
  • Body
    3 Results
  • Door
    3 Results
Find part by diagram >

Question and Answers

Q:

why won't my kenmore gas range model no. 3627536891 bake?

A:

With the bake option not working on your range can be rather concerning. I have done some research on the Manage My Life website and have located several links similar to your issue. While you are waiting for a detailed reply from an expert I have provided the links below. Hope this helps!

Read More
Priscilla V -
May 17, 2012
A:

I can understand how this would be a very frustrating problem to have. It sounds like there is more of an issues with the ignitor, then the other parts. This is the one that is most likely going to stop working. However, I would suggest that you test this before you replace it. You will need an Ohm/Volt meter and you will be looking for 120 volts on both wires. If you are not getting this then replace the ignitor. If you need further assistance, please reply to this thread. Thank you for using Manage My Life.

Read More
AnneJ -
Sears Technician
May 18, 2012
See more answers
Q:

How do I replace the surface burner switch on my Kenmore stove?

A:

You will need to lift up the top & remove the front manifold. Please see the images provided below that explain the switch replacement. Be sure to turn off the power first.

Read More
biker dave -
Sears Technician
March 17, 2009
Q:

How do I light the pilot for the surface burners on my Kenmore stove?

A:

There will be no need to raise the top because there is no "Pilot" light. There is no pilot to light for the surface burners or for oven. It uses spark igniters for the surface burners and glow bar igniters for the bake and broil burners. The surface burners does not have or use a standing pilot flame, it uses the spark of the electrodes to ignite the gas coming out of the burner. The stove top will hinge open, but only after the screws have been removed from the burner base on all 4 burners.

You indicated that you hear the clicking, but did not indicate if see the sparking between the burner cap and the electrodes. If the burner cap is not sitting correctly on the burner head it will not ignite or ignite properly. For proper operation of the burner, the alignment of the orifice holder, orifice, air/gas mixer tube and electrodes must be correct.

Note: I added an image with the Care and Cleaning of the Burner Heads.

I recommend calling a service technician to diagnose and repair your range.

Read More
Joey S -
Sears Technician
August 11, 2008