Model #36275320101 KENMORE Free Standing, Gas

  • Gas & Burner Parts
    3 Results
  • Control Panel & Cooktop
    3 Results
  • Body Parts
    3 Results
  • Door & Drawer Parts
    3 Results
Find part by diagram >

Question and Answers

Q:

The oven takes extremely long to raise temperature. 36275320101 Kenmore Gas range

A:

Thank you for your inquiry on your Kenmore Range, Model: 362.75320101. From reviewing the details on your model, Based on your symptom and details; the glow bar igniter is weak. The igniter must pull enough current/amperage to open the oven gas valve. When it gets weak it will take the gas valve along time to open and supply gas to the bake/broil burner.

Safety Warning: Before beginning the repair, disconnect the direct power supply to the range to prevent the risk of injury or any electrical shock.

If you don’t feel comfortable or confident in this repair, then you can have it repaired at home by a sears technician. I have the included a link to the website: Sears Home Services or call 1-800-469-4663.

I hope this answered your question. Thank you for contacting SearsPartsDirect.com, and have yourself a wonderful day. 

 

I apologize for the inconvenience. Thank you for contacting SearsPartsDirect.com, and have yourself a wonderful day. 

Read More
Gerry 93 -
Sears Technician
July 07, 2015
Q:

why does whin the oven starter comes on it takes severial minutes to ignight ? 36275320101 Kenmore Gas range

A:

when it comes on the temp indicates 450 temp is 250 ??

Read More
russell -
June 29, 2015
A:

is there a site that can show how to trobleshoot

Read More
russell -
June 29, 2015
A:

is there a site that can show how to trobleshoot

Read More
russell -
June 29, 2015
A:

is there a site that can show how to trobleshoot

Read More
russell -
June 29, 2015
A:

thank you for all your help you are ferry good rspj@kc.rr.com

Read More
russell -
June 29, 2015
A:

Thank you for your inquiry on your Kenmore Range, Model: 362.75320101. From reviewing the details on your model,If the electronic glow bar bake igniter is not glowing when the bake cycle is started, the electronic oven control/clock assembly is likely faulty. If the bake glow bar igniter is glowing, the bake igniter is likely too weak to pull enough current/amperage to open the oven gas valve. You will need to remove the oven floor in order to access the bake igniter. There should be couple of screws at the back of the oven floor to remove. Lift the back of the oven floor up and then slide it out from under the front oven frame to remove the oven floor.

Safety Warning: Before beginning the repair, disconnect the direct power supply to the range to prevent the risk of injury or any electrical shock.

Caution: Contents inside the washer unit could have sharp edges. Make sure you wear protective gloves during the repair.

If you don’t feel comfortable or confident in this repair, then you can have it repaired at home by a sears technician. I have the included a link to the website: Sears Home Services or call 1-800-469-4663.

 

I hope this answered your question. Thank you for contacting SearsPartsDirect.com, and have yourself a wonderful day. 

Read More
Gerry 93 -
Sears Technician
July 03, 2015
See more answers

Top Parts