Model #3627391591 KENMORE Range (gas)

  • Burner Section
    3 Results
  • Main Top Section
    3 Results
  • Cabinet
    3 Results
  • Door
    3 Results
Find part by diagram >

Question and Answers

Q:

The oven is not heating correctly 3627391591 Kenmore Gas range

A:

Thank You for choosing Sears PartsDirect.com and being a valued member. It is unfortunate to hear that you are having issues with your oven and I do understand your frustration. Glad to help out. I'm looking at your model number 362739169 and from your description I suspect that the pressure regulator is failing. It seems as if the regulator is not allowing the appropriate amount gas into the burners. Here is a video that will help with troubleshooting the issue. Just click the blue link above to be taken to the page. I trust this information will help you.

 

Thank you for choosing Sears PartsDirect.com.

 

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact Sears for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Sherman_G_Wallace -
Sears Technician
October 16, 2014
Q:

The oven is not heating correctly 3627391591 Kenmore Gas range

A:

Thank You for choosing Sears PartsDirect.com and being a valued member. It is unfortunate to hear that you are having issues with your oven and I do understand your frustration. Glad to help out. I'm looking at your model number 362739169 and from your description I suspect that the pressure regulator is failing. It seems as if the regulator is not allowing the appropriate amount gas into the burners. Here is a video that will help with troubleshooting the issue. Just click the blue link above to be taken to the page. I trust this information will help you. 

 

Thank you for choosing Sears PartsDirect.com.

 

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact Sears for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

Read More
Sherman_G_Wallace -
Sears Technician
October 16, 2014
Q:

Kenmore Range 362.7391591 Oven not heating properly

A:

I understand how important your range is to you. I took the time to research your question and found a link that will provide you with some information about this type of issue. I hope your range soon works properly!

Read More
Jackie S -
September 19, 2011
A:

Thank you for your question. I'm sorry you are having this problem. The information you have received from Jackie is very good. This could be a problem with the electronic control or the sensor. Normally when the temperature is this far off, the control will not adjust this much. I recommend having a technician check this. If you have a meter and would like to check the sensor, first disconnect the power to the range. The sensor will be located in the upper section of the oven. Remove the screws holding it in place and pull the sensor out. Disconnect the wires and with the oven at room temperature (approx. 72 degrees) and the ohm meter set at Rx100, check resistance across the two sensor leads (should be approx.11OO ohms). If it is in this range, the electronic control will need to be replaced. I hope this will help you. If you would like more assistance, reply to this thread and I will be glad to assist you further.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Scott D -
Sears Technician
September 21, 2011
A:

Do you know the part number of the electronic control and roughly the cost? If it's too expensive it may be time for a new range.

Read More
Molly -
September 21, 2011
A:

The part number for the electronic control is # RFR-CCS and the cost is $149.99 not including shipping and tax. It's available at the link listed below. This is a substitute part. The original is no longer available. I hope this helps you.

Read More
Scott D -
Sears Technician
September 21, 2011
A:

Thank you for the information. Now we have to decide if we want a new range or get this one repaired. You have helped immensely!

Read More
Molly -
September 21, 2011
A:

Thank you for using Manage My Life.

Read More
Scott D -
Sears Technician
September 21, 2011
See more answers