Model #3627361193 KENMORE Free Standing, Gas

  • Burner Section
    3 Results
  • Main Top Section
    3 Results
  • Cabinet
    3 Results
  • Door
    3 Results
Find part by diagram >

Question and Answers

Q:

Looking for complete conversion kit for Kenmore range Serial 3Z208048P model 362.7361193. I am converting from NG to LP. Where should I look for 1? 3627361193 Kenmore Gas range

A:

Thank you for choosing Searspartsdirect.com and being a valued member. I can certainly assist you in locating the conversion kit for your range. 

I do apologize the manufacture does not sell a kit for this model. You would have to purchase the parts separately. 

WB28K0022 lp orfice spud
  
WB28K0087 RT Rear lp

I have also attached the conversion instructions. 

You can also visit searpartsdirect.com for parts, diagrams, and repair information.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Thank you for your question. Have a great day.

SAFETY NOTICE: Be sure to disconnect power to the appliance before performing any repairs. If you are not comfortable with doing any voltage checks that might be recommended, please contact your local service provider for repairs. Be aware that there could be sharp edges inside the appliance that could cause cuts or other injuries to yourself or others.

 

  

Read More
Natasha12 -
Sears Technician
May 29, 2015
Q:

What does F2 error on 362.7361193 gas range mean? 3627361193 Kenmore Gas range

A:

Thank you for choosing SearsPartsDirect. I will be more than happy to assist you with your Kenmore range.

From the information you have provided above, the electronic control board likely has a stuck relay; replace the electronic control board. If the oven is at room temperature, the oven temperature sensor could be defective. Unplug the range, disconnect the oven temperature sensor and check the resistance of the oven temperature sensor using a volt/ohm meter. The oven temperature sensor should measure around 1100 ohms at room temperature. If the resistance is off by more than 200 ohms off, replace the oven temperature sensor. If the resistance is normal, replace the electronic control board.

I hope you found this information useful. Again thank you for choosing Sears, we appreciate your business, have a great day.

Read More
Benny23 -
Sears Technician
December 24, 2014
A:

Thank you for the quick response. The information was very helpful. Happy Holidays.

Read More
Spencer -
December 25, 2014
See more answers
Q:

converting range from lp to NG

A:

I know this type of information can be very helpful for you to have. While you are waiting for your expert answer, I did some research on the unit. I was unable to locate information that would be helpful with regards to your question at this time. Your expert will answer within 24-48 hours with detailed information. Thank you for using Manage My Life.

Read More
Alina F. -
December 09, 2011
A:

Thank you for your question and I understand your concern.

I added an image below that may be of help. I was not aware the orifice sleeve was removable. The low simmer orifice should be removed in the same manner as the other three. See images below.

The bake and broil burner spuds are located where the gas line enters the bake and broil burners. I added a third image with a red circle drawn around the spuds.

I hope this is helpful. If I may be of further assistance as more details become available, please reply to this post.

Read More
Joey S -
Sears Technician
December 12, 2011
See more answers