Model #3627361191 KENMORE Free Standing, Gas

  • Burner Section
    3 Results
  • Main Top Section
    3 Results
  • Cabinet
    3 Results
  • Door
    3 Results
Find part by diagram >

Question and Answers

Q:

I have a 25 yrs. old Kenmore gas range, model. 3627361191 showing F3. Oven won't stay on. Can't find my manual. HELP!

A:

Error codes can leave the homeowner guessing. I did some research and located a similar question for this model tat may help while you wait for the expert. I attached the link below. I also added the link to Sears Parts Direct for any parts needed. I hope this helps toward resolving this error.

Read More
Barbara H. -
June 03, 2012
A:

Thank you I appreciate your answer & will check it out.

Read More
Pat -
June 03, 2012
A:

I know that it can be very difficult to have issues with your range, especially when you need to use it. The technical information regarding these error codes is shown in the image below. If the oven is overheating and one of the elements will not shut off then your likely failure is the electronic oven control board. If F3 error codes are being displayed when the oven is off (or apparently not overheating) then the oven temperature sensor probe is the likely failed component. You can check the resistance of the sensor probe with a volt/ohm meter. You can also check the wire harness connections between the electronic control board and the sensor probe. If you need parts, you can order them from the Sears Parts Direct NOTE: The information below is intended for technicians. Follow electrical safety guidelines when using this data. Unplug the range to disconnect electrical power before accessing internal components. Internal metal edges in the range can be sharp. Protective gloves are recommended. I do not recommend that you perform any live voltage checks on this range. You should be able to determine the cause of your problem using resistance checks and wiring connection checks. If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services . If you need further assistance, please reply to this thread. Thank you for using Manage My Life.

Read More
AnneJ -
Sears Technician
June 05, 2012
See more answers
Q:

Kenmore Gas 362-7361191 not baking correctly

A:

I'm sorry to hear that you are having some difficulties with your range. I did some research for you at Managemylife.com and found an expert answer to a similar question that may help until your expert can respond to your specific question. The link is attached below. If you do decide to schedule service and have a qualified technician help you, I have also attached a link to Searshomeservices.com. I hope these links provided assist you.

Read More
Barbara H. -
November 26, 2011
A:

That link for a previous answer describes the likely failures that would cause this oven heating problem in your range. Based on your description, you likely have a weak glow bar igniter (part WB2X9154). I provided a theory of operation for that ignition system on your range in the image below. If that igniter is glowing but the gas burner is not igniting consistently as you seem to be describing, then you can likely fix this problem by replacing that igniter. You can order that part from the Sears PartsDirect website. Here is a direct link for that part: Igniter . Be sure that you unplug the range and shut off the gas supply before accessing internal components and replacing that igniter.

If you need more help, reply with additional details and we will assist you further.

If you do not feel confident repairing this problem yourself, then you can have it repaired at your home by a Sears technician. Here is a link for the website: Sears Home Services .

Read More
Lyle W -
Sears Technician
November 29, 2011
See more answers
Q:

need kenmore range 362-7361191 owners manual

A:

I was able to locate your manual off this site. I hope this is helpful!

Read More
Jackie S -
August 14, 2011
A:

thank you.

Read More
troy -
August 14, 2011
A:

I see that Jackie S. already provided you with a link for that manual. If you need more help, let us know.

Read More
Lyle W -
Sears Technician
August 15, 2011
See more answers